Separate names with a comma.
Some features disabled for guests. Register Today.
Please post your grbl settings here so we can have a look at them. Alex.
Absolutely. I cut aluminium and even mild steel with a RoutER11 (RoutER11 CNC Kit) Alex.
G53 (use machine coordinates system) G0 Z-5 Alex. EDIT - should have said that needs to be on one line.
Hot Knife Foam Cutter Acro 1515 with belt and pinion z-axis Blackbox Settings? Alex.
Copper work hardens, but quenching hot copper anneals it. Soft metals can actually be more difficult to cut than harder ones. Let your copper cool...
You can split longer jobs into shorter segments (tape splitting) using the Openbuilds post processor for Fusion. Fusion 360 CAM changes Alex.
G54 is the default on switch on, G55 to G59 you have to specify in your g-code or select in your control programme (eg Openbuilds Control)...
OK, to explain G53 (and G54) - a cnc router has a MACHINE co-ordinate system which is used as a reference (g-code for that co-ordinate system is...
You are correct, - move the jumper to 24 V. sorry about that, memory playing tricks. The sensors Ratrig supply have a VERY short range, so...
Have you used Openbuilds Control troubleshooting tab to check that signals from your sensors are reaching the controller? Check that you have...
Please make a back up of your grbl settings and post them here. And, as @Peter Van Der Walt asked, please clarify which controller you are using....
Duet is very flexible on its outputs [ATTACH] Full info here; Duet 2 WiFi and Ethernet Hardware Overview Alex.
Trial run for a memorial plaque for my wife's grave. JPG converted to low relief (STL) using blender. Slate machined on my Workbee (upgraded with...
As @Giarc and @Misterg said. You do need to set the workplace coordinate system zero (set XYZ) in the same place on your workpiece as you set the...
The T6 bit means it has been tempered to make it more machineable, but you shouldn't have much trouble with 6061. Are you seeing any signs of the...
1st question - what alloy? They are not all machineable. I use 6082T6 or 6061T6. On a workbee with V-wheels I used 10~13 K rpm, 3 mm single flute...
With the power off, disconnect the Z motor. Make sure wires can't touch if they are not in a connector plug. Power on and try X and Y axes. If...
Can't read that - please use a screenshot or the windows snipping tool. From what I can see you have not selected a wcs in Fusion cam setup. What...
Then you need to use a grbl post processor. If there isn't one listed (cam programmes will often have metric and imperial versions) you will have...
