Separate names with a comma.
Some features disabled for guests. Register Today.
That rather depends on the controller you are using - you need to use a post processor which is compatible with the controller you have. Alex.
Yes! Alex.
As @David the swarfer said, but also are you using the personal use license for Fusion? If so Autodesk took away rapid moves from the post...
Use the troubleshooting tab in Openbuilds Control to test the limit switches. You may have to toggle the polarity of the switches if they are...
What toolpath are you using in Fusion? - the surfacing toolpath ALWAYS moves beyond the stock box dimensions. If that is the issue use a pocket...
Check that your leadscrew bearings are OK and that they and the lock collars are properly seated. Alex.
Do you mean you need the outline - a contour toolpath? If so create a contour toolpath with a shallow depth and use an engraving bit to trace the...
See Problem with tool chatter only on one side along the Y. The first thing I would check is the eccentrics on the X and Z axes, but could also...
Are you pressing "set Z" after the probe routine? If so, don't - the probe routine sets the Z zero. Alex.
Try reducing feedrate, and definitely try conventional instead of climb. These tests will give us clues about what might be causing this. Ideally...
What are your speeds, feeds and depth of cut? Have you tried conventional rather than climb milling? If so did you still get chatter? Alex.
I use a RoutER11 for everything from soft plastic to mild steel, including quite a lot of work with aluminium. Shifting the extra weight of a...
I haven't found any limitations. You have to download it again every time they bring out a new version because files saved in a new version won't...
@Giarc - if you don't need to see the g-code the trial version of Aspire will open a Vectric file which can sometimes be useful in helping with...
What are your grbl settings, especially $27. This is the pull off distance and it is explained here :- grbl/doc/markdown/settings.md at master ·...
Sorry, should have put "if so" in that last sentence - see Setting up proximity sensors Alex.
Are your microswitches normally closed? Your original post suggests that you had a permanent "triggered" signal from your sensor. Try changing $5...
Wouldn't affect the wcs Z zero - would offset X and Y and stop 0.5 mm before reaching the full Z depth. Alex.
As @Peter Van Der Walt said, wiring on that motor is the first thing I would check. Re V-wheels you have a little adjustment with the play in the...
So, V carve pro V6.5? (Program Updates〡Vectric) That may not help you though as it looks though you will need a grbl post processor - before my...
