Separate names with a comma.
Some features disabled for guests. Register Today.
yes, was also my guess but if such report can help to improve the things... was my intention
Hello The toolpath created by Fusion 360 sounds good but the one shown in Control is really weird in some places. I opened the same GCode in...
which function??
My bit was not deep, just at the right level (there was a mark on the bit) duct tape is interesting solution!
Ok interesting I just did my first job and do it the following way: - put the bit in the spindle but without tighting it (due to gravity, bit is...
One more question for the same topic: setting Z0 I thought it would more precise, less risky etc to make the bit touch the surface of the board...
Hi I am willing to design my wasteboard with a M5 hole/insert grid (spaced every ~5cm which sounds a good value looking here and there). I plan...
I took a look in Fusion and in machining time, there is a parameter for "rapid feed" (which is when the tool is moving outside the material) which...
I did run it and it takes about 30min (to remind Fusion said 10min and Control nearly 4h)
Thanks to both of you, much clearer now!
So the Machine Coordinate System is not visible neither editable? In OpenBuilds Control, I just see the WCS?
Hi, I am confused and as I am newbie I am sure it is an easy question for you folks. I am willing to my first job which is drilling my...
yep but my goal was to simulate in order to be sure my values (feedrate typically) were correct before to run the job :)
Agree that the difference is so big that there is something strange somewhere...
Hello Did a job in Fusion 360 and generated GCode. I also did simulation in Fusion and it gives me a machining time of 10min22 (in gcode...
ok thanks for the hint!
ok while trying to send the $$, my (too old?) laptop was not really responding. I opened task manager and realized that there were 4 instance of...
1/ yes it is the page I have used to check it 2/ they have worked during some hours so cannot be wiring (I have Xtension limits)
Hi I played some hours with my new LEAD CNC machine. I have set the steps/mm etc Everything was working fine even if I had the machine going out...
I mounted back everything, mixing things....now I am not 100% satisfied but it is far better than before...
