Separate names with a comma.
Some features disabled for guests. Register Today.
Inventor and I believe fusion has an auto annotate button It's not very clever tho, it literally covers a drawing that has angles with...
Checked the resources section?
dependant on what im doing.. if we are talking about spoil board flatness, if i need flatter than that after i have faced it off.. i simply run...
Maybe braising is the way to go if you need to repeat. you should be able to get over that with shims, if it's where the linear bearings are, or...
here's a link to something similar to what i had in mind.. its abit more expensive than the type i was thinking of but cant for the life of me...
Planatary gearboxes over microstepping is definitely the way to go, increase the steps per without being detrimental to torque as you would using...
What nuts/ linear bearings and carriages are you running? Do you have metal on metal moving parts? All of which do really require lubrication, if...
hello, again another post of mine that I'm not sure is going to be of interest to anyone but here goes my cheap *** solution/experiment to an...
a nylon rack would be the obvious choice and the principles of actuation are the same as with a steel rack and certainly would be an improvement...
Not too bad if you go for a plastic derived one
What type of screw? Tho joe is right r & p for 4m is your only option really. Leadscrews will be too slow and likely bind up with screw sag and...
Yeah I have had a go at that, but found if you make them too sharp the edge can round over after a while. And most of these things are never...
wonder if there would be a market for a punch with a spring loaded foot mechanism, not even sure what they are called lol possibly with...
Your x looks good btw.. just the dual y's that need a bit of attention. Slot the x motor mounting holes will allow you to get some preload there....
No problem, I personally measure preload with a torq wrench, its important you have adjustment on the mesh.. my motors pivot offset of center of...
Yes, it's really the best way without measuring the amps but not all of us have a couple of thousands worth of probes laying around to do so...
Yes ramping is very handy. Only time ramping shouldn't be used, well at aleast one time, is when your using compression spirals where you need...
Just a good idea to use a ramp in move with these bits, only difference really.
The foam actually makes a big difrence, is now doing it one without catching :) [MEDIA]
You can't go off the pots with these type boards, They are rated on peak amps and not repeatable amps so will be underpowering the motors if you...
