Separate names with a comma.
Some features disabled for guests. Register Today.
Note, I don't heat my 12x12" bed at all for PLA. Slather a 1:1 solution of woodglue and water on there, touch it up with hairspray from time to...
OHHHh..... nice! Going to get some right now! :)
Question: Do you mean you can slide them straight into the face of the v-slot? Like, if the ends are capped, you can sneak them in that way?
Sounds like you'll have a good time making a great gift for yourself ;) Speaking of holiday builds, I just ordered the 1000mm X-Carve kit as my...
@Carl Feniak " How are you liking your modified Z axis locations? Recommend for others with large beds? " : It seems so much (visibly) more stable...
;) That manual support system has got a lot of comments on the interwebs. I should try and patent it... No wait, I think I'll go open source... :P
Have I mentioned how much I love this printer? 9 hour, 20" tall reindeer last night, plus a timelapse: [MEDIA] 300 micron, 90mm\sec, .6mm volcano...
To echo @CapnBry, yah, the new direct-drive is awesome. I just printed the below Eiffel Tower: 69 hours, 150 micron, .6mm nozzle, 60mm/sec, 20"...
Just an "fyi" : Got Octoprint up and running on my cbot. Not necessarily cbot directly related, but I did do a slight mod to the camera mount to...
Not at all: I presume you mean my Configuration.h and Configuration_adv.h? Find attached
@adamcooks : I don't think there is any sort of pendulum effect: I have zero slop in my x-gantry, and I can't imagine what I'd need to put up...
Just got the 'beta v2' Direct Drive setup printed and installed last night. Thoughts on it: Based on my Rep1's print of it, the tolerances for...
Yah, I wasn't too sure about the push-fitting, but I really don't care: That's what zip-ties are for :P
FYI, just ordered some 3mmID PTFE off McMasterCarr to try out with the new direct drive setup: McMaster-Carr Could have got it for less from...
Off the bat, have you done a calibration cube with that PLA? Your extrusion multiplier is .9, I usually run PLA .95 -> 1.0. It feels like it's...
I'm thinking the same thing: Something with a larger ID than the 1.75 ptfe used in the extruder (like what my Rep1 uses for it's guide tube,...
Here's my opinion, take it for what you will :) Volcano nozzles generally print with slower speeds, but a higher extruded volume, thus ultimately...
Great, thanks for that design update @Carl Feniak ! FYI, I just knocked out a 3dbenchy, with really no print tuning yet other than dropping the...
@Carl Feniak , to echo @CapnBry , huge thank you on this upgrade: After swapping back to my brass .6mm volcano nozzle, I printed out a...
Ha @CapnBry , sounds like we have two different print settings ;) My nut traps were a little small: I had to use pliers to get my nuts in there...
