Separate names with a comma.
Some features disabled for guests. Register Today.
How deep should a compression bit be on each pass? I did buy 2 spiral up cut bits just in case. What about cutting depth for these?
Well, I think I've been staring at the screen too long or inhaling too much sawdust lately. I did an aircut this evening of the same file to...
Ryan: I've attached 4 photos showing my CNC basement set up. After reading your post about static build up I think I may have one giant static...
I have a metal wire attached to the router mount and up and through the dust hose and grounded at the plug receptacle. The router cord is in...
Previously, I had posted about my OOZnest 1500x1500 going off the tool path course on the 5th or 6th pass and coming to a screeching halt in...
You're welcome. Ryan Lock from OOZnest has been very helpful to me getting my 1500x1500 up and running. He told me about the fast decay soldering....
Ryan: From the other feed back I've been receiving on other forums, it does seem that my feed-rate is the most likely culprit. I've got a lot of...
Here's chance for me to give back to the forum. Rob: I needed to do the same thing for my machine to run better. At the local hobby shop I...
While test cutting some Baltic birch plywood for my sculptures recently, twice the router has gone off course resulting in some loud screeching...
Yesterday, I sent this same file and the machine was able to draw a pencil sketch of my design without as much chatter. The larger objects were...
It seems that I can now do small and large movements without any problem. However, when I send a g-code file for the machine to follow (air, no...
Everything is stock from the OOZnest kit: Nema 23's 1.8 step 24v-360w 22 awg
I just finished the build for the OOZnest 1500x1500. The X & Z axis worked perfectly from the start. I am however having problems with the Y axis....
I'm running Windows 7 and am attempting to commission the Xpro V3 according to the OOZnest Electrical Assembly Instructions on page 35. I have...
Ryan: I did as you suggested and cut off the factory supplied ring terminals, stripped about 3/4" from the two wires insulation, wrapped the bare...
I've finished building the OOZnest CNC PSU and discovered that the voltage meter is not working. I live in the United States, so before plugging...
Ryan: Thanks for the tip! That helped quite a bit. I also found it beneficial to tip the assembly on it's side so that the eccentric adjusters...
