Separate names with a comma.
Some features disabled for guests. Register Today.
I am using Vcarve to design and then generate the tool paths. The cuts made were in 1/8" plexi using a very cheap HQMaster 1/8" End Mill...
Peter - I did complete the calibration upon set up (prior to any cutting with the machine) -- I then after these plexi glass cuts did Y movements...
I believe my machine or software is causing a dimensional problem and looking for suggestions to troubleshoot - Help Please [IMG] I created a...
Thanks - I am still not sure what the G-code is to start off with Z and where you'd position it. This touch probe has a circle at the bottom left...
I am new to CNC hobby and I bought a plate off of Amazon but then it didn’t have any source details for setting up the necessary G-Code to use the...
What is the recommend windows based PC/Laptop/Tablet for running OB Control? I am just getting started using the BlackBox with OB Control and I...
for $4 I only see Enable and Disable.
On my meanwell PSU I did switch it to the 110v so I am good on that part. Sorry for not knowing this but was is "$4=1 in grbl" ? I presume...
I got my blackbox in hand and built it and now I just want to ask..... any common mistakes that a novice would do that will kill the box? I know...
Ok so back to the stall setting procedure... that must adjust the voltage internally I assume. Thanks.
Thanks for that information about the macros. I am going to be using nema 17 so should I be using a 12v power supply to the blackbox or a 24v...
Thanks - Another question if you don't mind... Is it possible to use a touch probe block for setting not only the z but the x and y to the corner?...
Ok. I always thought that there was some sort of test done with a multimeter to set the correct current. So this is just a swag. I understand...
Adjust Stepper Driver Current ??? What does this really mean ?? "Adjust the current until you can no longer stall the motor under normal...
Purchased this steel table on Craigslist from a guy who was going to use it as a CNC Plasma table but lost interest. I have modified the table...
