Separate names with a comma.
Some features disabled for guests. Register Today.
also make sure you have the current version from github and not what's in the C-Beam folder as that version is old. I also saw that a new version...
C-Beam wiring. I am at that point where I need to wire everything up and at first I am just going to get everything 'out of the way' but I am...
looks like a great design there...do you have any issues with the center of the material bowing up any?
I have finally found the right terminology for this (darn newbie) and that is Z probe. I found that the A5 pin is assigned for this but looking at...
looking at the settings page again and wanted to confirm that if you are using inch vs. metric that all of the settings that show mm (i.e. $100 is...
glad to hear you are thick skinned...I have 7 years in a software development company and many many years of alpha and beta testing so I tend to...
ok now I just feel stupid...didn't realize you could change the increments on the settings page and they would carry over to the interface page so...
looks nice and I assume your DOC was .2mm not .2"
so what are you looking at in the settings because I don't see anything for the jog feed rate other than on the main jogging interface and that...
@Moag Yikes on the computer crash...I have been fortunate to only have a couple of those and have found Google drive is a godsend since I can keep...
CornerStone
new question here...got the beast to move last night but have a question about jog feed rates. the fastest rate is 100 but what if I wanted it to...
@Sony Lowe, for #2, if you are using an ATX power supply then the 12V 'input' at the bottom right of the board is now a 12V 'output'
got the new tap yesterday (have to love Sunday delivery from Amazon) but haven't used it yet. I DID get everything assembled and did a temp hook...
ok....do you have any info on that tool probe? I am not at that point yet but can see how that will make life a LOT easier for zeroing out tools...
GREAT info there. I know I don't have a spiral point because the chips were just bunching up so there was a lot of in and out and in and out and I...
tapping (14) 1/4-20 holes in 5/8 6061 T6 is a ***** and tapping fluid is your friend!
that was a lot easier than I expected. put an old 60 tooth carbide blade in and used a cross cut sled and took .125" passes. The only thing I...
I was going to say the same thing until Rick 2.0 pointed it out. I saw something similar done in a wood shop and there was a big touch screen...
very nice....what was the cut time on that?
