Separate names with a comma.
Some features disabled for guests. Register Today.
Looking at the ChiliPeppr code it looks like he sends G21 G91 (Use mm and rel coords) then G38.2 Z-20 +(config stuff) which initiates the probe....
Yes I'm connected to ZMIN and I do use the Touch Plated widget in ChiliPeppr.
I'm using the TinyG ver. 8 with .97 firmware, I have my switches defined as NC with the Z max as limit & homing, Z min as disabled. My touch...
Just wire the input of SSR to ground and the pin labeled SPIN for router power control and to COOL and ground to activate the air relay. In the...
I use all the Min/Max inputs for sensors and my Zero plate, I do have an E-stop but it breaks the 24VDC that feeds everything. Instant kill on...
I have and it's a great mod. I used a surplus SSR and later ordered a backup off of Amazon. Any SSR with 3-32VDC input on control side and an AC...
I'm mostly using solid carbide single flute bits, mostly bought on amazon. All are 1/8" dia cutter of various length. All are designed for...
Change the x & y to 1500 mm per min change The z to 800 mm per min and give that a try. You're Not going to hurt anything setting it lower. FredQ
Yes I started out at 20 but found that I could get up to 30 and still get good results. I think the shakes is more the chip load coming off the...
That's what they advertise but I have no way of measuring it, yet... FredQ
I use the Dewalt 611 at its lowest speed on the dial. FredQ
I'll add that I had severe problems earlier when I had a job that made a long X axis run across the board during the job. It would stop and...
I run a TinyG also and have also been concerned if it will over head on big jobs. I start a BIG job last night, 500,000 lines of G-Code, and it...
I've been cutting lots of 6061-T6 aluminum lately using a .125 single flute cutter. Running at 30 IPM with a .0313 DOC and I can't imagine...
With all this talk about the Dewalt 611 I though I might relay some info from my own build. I was concerned with the Dewalt in the supplied mount...
Go to this link, down load the zip file (not the source code zip), unzip and you will find the exe programs to run GRBL... Releases ·...
