Separate names with a comma.
Some features disabled for guests. Register Today.
@Peter Van Der Walt can you possibly shed some light on this?
When setting the output voltage of the 24V PSU, do you set it right at 24V or give it a little nudge for expected voltage drop when under load? I...
will I have an issue switching 48V (.0375a) contacts on a relay? Would I benefit in any way pulling down to 12V or so?
Is there any documentation on the "Dual configurable onboard Relays for Plasmas, Spindles, etc” (ie; what is configurable about them, how do I go...
Ah gotcha, yeah that was a drawing I just threw together as a quick reference. Thanks for looking out!
I just looked at the X32 documentation again and am not sure which resistor you are referring to. Will you elaborate on this?
I’ll take a look at that as well, thanks for the help Peter!
It does, I was actually going to use the “tool” enable output to trigger a n mosfet in place of the spindle controller On/Off switch, if possible....
Not sure if this helps but when calibrating the 0-10V output, I noticed that it was possible to get up to ~15V at 100% drive command. Should it...
No, it does not.
Spindle disconnected, PSU disconnected, USB cable connected to computer but disconnected from control software. I get pretty much the same...
The results I posted were after an M5 had been sent. I can completely disconnect the power supply from the X32, disconnect from OB control...
Attempting to use the 0-10 VDC output signal to control my 48V spindle PWM controller. I have calibrated the 0-10 output to “10 VDC exactly" but...
Weight and torque aren’t a problem but I have been avoiding using an actual router because I use my CNC as a “desktop” unit in every sense of the...
Thanks Craig! This looks like what I need but I’m still novice enough to admit I don’t fully understand all of the specs myself. Any other...
I recently decided to upgrade to the X32 from my generic GRBL controller due to what appeared to be missed steps and general communication issues....
