Separate names with a comma.
Some features disabled for guests. Register Today.
As the title says - I have been noticing that the Openbuilds Control will randomly pause in the middle of a program. Some programs are fine,...
You can get a similar relay from Langmuir Systems - look under their MR-1 options and there appears to be a similar relay for sale. Not sure if...
For anyone following this thread - I gave up on the GT-series VFD. I simply don't have the time to keep chasing random faults and issues with...
Great, thank you for this.
Blackbox does trigger the relay briefly upon startup... This is the problem. In the coding, is there a way to turn this off during the initial...
I appreciate you taking the time to edit and compile the hex file. Unfortunately, the "use spindle DIR as enable" option doesn't work. When the...
thank you, I appreciate it!
Yes, I have contacted and spoke with the VFD manufacturer. I’ve mentioned this a few times. “Mike” at Huanyang is helpful to a point, but there...
Ok, I discovered something interesting, maybe you could help me figure out what is going on here... I opened the black box and checked the relay...
Thinking about that relay idea - I went back out and tested both the S1 and the COM terminals in their standby state. Findings: 1. COM terminal =...
Ok, that would make sense on the spindle end - one of the issues with this spindle is the U, V, W, and ground connections. The plastic cover that...
I was just trying to run up the spindle again, made no changes and now I am getting error codes. OC1, OC3 OC1: over current when acceleration....
Nearly all set ups that I have been seeing or reading about use the Huanyang HY series VFD. I haven't seen too many with the GT series. Someone...
I was able to activate the spindle from the blackbox, kind of. On the blackbox command signal pin out, there is the following: 1. Ground 2. PWM...
I am not seeing any indication whatsoever for the J16 jumper in the manual. I have tried several variations with the jumper in both voltage and...
I was able to find the J16 jumper location (see attached photo). Its accessible by removing both front covers on the VFD. There is no indication...
I did see a post floating out on the web where the AI1 input series of parameters was recommended for the 0-10v control, but I don't think this is...
I'm doing the best I can with the manual but its not the most enlightening material. Was hoping someone else has blazed this trail. I did...
Has anyone used a Huanyang GT series VFD with the Blackbox control? I am trying to figure out how to set up the VFD to accept the 0-10v / PWM /...
Thank you, I appreciate the share. I decide to go a different route with this and simply made a single on/off/e-stop that splits into the 120v...
