Separate names with a comma.
Some features disabled for guests. Register Today.
we need to do this step by step (remember to reset the controller after changing and saving settings) 0 - at this point you probably need to make...
"top height must be below plasma tool pierce height (links tab)" all explained here OpenBuilds-Fusion360-Postprocessor/README-plasma.md at master...
yes, OB parts can do this. I recommend buying 2 of the ~1.5 meter belt drive actuators, power supply and Blackbox and get something going. Once...
that will depend on the the present stepper motors. What voltage are they running at? What current are the present drivers supplying? The Black...
no brackets in comments! a gcode comment can be (this is a comment) or ; this is a comment therefore comments cannot contain either semicolons...
all the controller settings are stored inside the controller, so plugging in a different computer will not change controller behavior.
As does sketchup make + sketchucam, which is still supported (by me), and if it works fine with your Xpro, keep going. No need to export to...
now , please do that backup of the settings.
I would just create a drawing and generate my own Gcode for it, that is all the wizard is doing. For fun I just tried it. open sketchup, draw...
yeah, power wires seperate from signal wires will always be better. this swing arm will keep the wire out of your way and reduce wear and tear,...
most of us have been using wheel guided machines for years without problems. They do need adjustment every 6 months or so, and while looseness is...
funny, we had one like this last week and I think it is the same thing. Check your retract setting in your CAM, it is probably trying to lift Z...
the initial seek limit when homing is 1.5 x the axis travel limit, so you have to set the travel limit correctly as Peter mentioned.
sadly the simulation does not know how to display the G28 nor G53 moves correctly. I think one could use the length set for the Z length to...
yes, your code contains a line T1M6 which is a tool change instruction that GRBL does not understand. The correct postprocessor will not include...
I would load Xubuntu on the PC and run bCNC as the GUI, but then I'm a geek (-: If you are keen to try this, there is a little dance you have to...
Backlash somewhere, feedrate way too slow, depth of cut too much. On a belt drive OX you want to be using more of a 'high speed machining'...
looking at Ball Bearing 688Z 8x16x5 the bearing is a standard part, so that infers that all the other parts are also standard and the only thing...
I believe you will be able to 'see' it if you mesh the 2 leadscrews together, side by side. 0.0005" not too hard to detect by feel (-: and by...
nope, not milled, rolled (-: which is why we have to calibrate after installation, the rolling process is repeatable but not accurate. I am...
