Separate names with a comma.
Some features disabled for guests. Register Today.
no, GRBL is not the problem (the other million users do not have this problem :-) ) , nor is the Gcode, the symptom you describe is mechanical and...
calibrate using the longest distance you can measure, that is more accurate. OpenBuildsCONTROL has a calibration wizard which makes it easy but it...
I think Peter talks about it: [MEDIA]
no, you must never do that stop the run (make a note of the line number where it stopped) adjust bit length probe Z with new bit length. restart...
the autodesk post uses G28 'preset position' for safety moves or a 'make no assumptions' option that will crash horribly if you are not careful....
because Home, Fusion360 and G53 Z moves
you need to remove the G92 offset G-Codes G92 offsets are dangerous, avoid using it issue 'G92.1' in the serial console rehome reset part zero...
using the troubleshooting tab in CONTROL, make sure that when you press the Z limit switch, the Z box lights up in CONTROL. Same for X and Y.
I think you need to contact the store about that Submit a ticket
this is not a 3D printer, G28 is not in any way associated with home on a router running GRBL firmware. G28 is a 'predefined position', just like...
yes it is overkill (-: only 1 side of Y needs limits, and rotaries usually go all the way round, there is no limit, unless you have a swinging...
you dont have a probe so you must turn off the touch off sequence. [ATTACH]
jog/cut directions must match the cartesian coordinate system of tool movement, this must be correct before you can home correctly. X+ is tool to...
There is, upgrade your wetware with actual Gcode knowledge (-: The <offset> in the file is a variable and not part of standard Gcode. The...
do make sure the stepper motor is NOT connected at the time , they can generate enough voltage to blow the drivers.
it is possible to mount the limit sqwitch upside down causing a short between the power and the frame of the machine, which will cause a reset...
not sure I understand what you are seeing..... home is machine 0,0,0 (Machine Coordinate System), set by homing when you 'setZero' you are...
love that! now i need one... or more...
either backlash or the head is nodding. as a test, put the work on a 2" thick block so the Z does not have to extend down so far.
I followed the NYCCNC channel's 'fusion Friday' videos for years, focussed short dives into specific things, rather than 2 hour long videos that...
