Separate names with a comma.
Some features disabled for guests. Register Today.
no, GRBL does not support a table of tool offsets, therefore CONTROL does not do so. it also does not support tool changes. but there are...
the acceleration and speeds you set for the controller are used for: accleration is used for all moves, both when starting and when stopping max...
being new you should read the GRBL wiki, yep, all of it. it will give you background info so you know where to look for any furture things to...
turn laser mode off in the GRBL settings grbl/doc/markdown/laser_mode.md at master ยท gnea/grbl
your enemy will be whip during rapid moves, but if you are happy to limit the maxrate to keep it happy, then it will be fine. you can also make/3d...
set the axis( jog) direction so Z+ moves it up then try a home and if it goes down instead set the 'home insvert mask' to Z goes up for the homing
look for a local model train club, one of them can just turn them shorter on his lathe (-:
because the switches have 3 terminals and you used the wrong 2 (-: typically there is a 'common' terminal and a Normally Closed (opens when...
used chatgpt to translate, you can too "When I want to export the file from Illustrator to CAM, vectorized, it exports incompletely, even though...
and check that in mounting the switches you did not mount them upsidedown and cause a short between the circuit and the frame
yes, you need to adjust the acceleration values for all 3 axes. the defaults (you did load a machine profile, right?) are usually quite slow but...
also, if it was working, there is no need to reflash the controller.
this is electrical interference, known as EMI. basically, the plasma spark is a big radio wave transmitter, and the arduino is receving the...
cutting up in the air means Z lost position. how hot does the Z motor get? if you cannot touch it for 5 seconds it is too hot, wich means it is...
then you need to do the 'fake-the-home' method, machiens always need a home How to 'Fake the home'
outlining the part is kinda like creating soft jaws from a part [MEDIA]
seems you need higher clock speed, maybe an ESP32 can keep up (240mhz instead of 16mhz on the atmels)? only caveat is to ignore the onboard ADC...
one does not 'find a script', one WRITES a script (-: in the Linux world the sed command can do it in 2 lines (generated by chatgpt, so subject...
why have you connected the laser to a coolant output? it should be connected to the PWM tool output so that M3/M5 can turn it on and off, but...
likely unrelated because the THC is not reading the Gcode at any time, right?
