Separate names with a comma.
Some features disabled for guests. Register Today.
Is the model of the MKS DLC32 that you have meant to be controlled from a PC, or is it intended to be a stand alone controller - I've seen...
In the simulation? I don't have Openbuilds Control on this PC so I can't run the simulation at the moment. Alex.
Is this the firmware you used? [ATTACH] I don't think your stepper drivers are really up to the job of running a cnc machine - they are OK for...
What happens if you set Z workplace zero above the spoilboard and run the file in air? Alex.
Can you post your grbl settings please? Check your $32 setting. Alex.
I can't see anything in that g-code that would cause that issue. One thing that puzzled me in your first post (I don't know anything about your...
As in the Autodesk grbl post? I thought that might be the case but I've not seen lead ins done like that - don't use that post. Thanks for the...
As @Misterg said, the only unusual thing I spotted in the file post processed with the grbl post was a couple of arcs in the YZ plane. I would...
That is not an error message - it is telling you that you didn't set a workplace co-ordinate system in Fusion cam set up, so it is selecting the...
Second the recomendation for the RoutER11 - I'm very pleased with mine. I don't work for Openbuilds by the way - just a satisfied customer. Alex.
NEMA 23 Stepper Motor would be a good choice. Alex.
Yes, but be aware that the number after "Nema" defines the mounting plate size. Check out the Nema23 spec (Google it) for the fixing holes...
I think the nema17's may also be part of the problem. Do you know the specs of those motors? It is likely that they are under powered for your...
If it's a profile or pocket cut and still lines up when it's gone all the way round you are not skipping steps - once you have missed a step you...
Please re-check your calibration - the pdf in the link below explains the theory, the video describes the calibration wizard in Openbuilds Control...
Options are, carry on using machine co-ordinates (G53) and choose the coordinates where you want to park it at the end of the job, or untick "use...
Are you using the Openbuilds post processor? docs:software:fusion360 [OpenBuilds Documentation] That uses the machine co-ordinates system to...
Sorry, missed that - bedtime here in the UK, but I'll try to have a look at it tomorrow. Alex.
I did ask if you could post your Fusion file - that might help us understand what is going on. Alex.
It's not your g-code - there is only one feed rate specified in the file you posted, and that is quite slow, so your machine is not doing what you...
