Separate names with a comma.
Some features disabled for guests. Register Today.
Uninstalled and loaded an old version. No dice there. So nothing at all to do with the program or platform. Something on my end. Read something...
Hello, not sure if its the issue, but this is after the latest round of updates. Have had no issues running for hours, 2 days ago, control...
Worked through everything above, no success yet. The box will not accept the flashing tool. Says the flash failed. Nothing wired up....
Thread from Peter I searched up. Good logic. I’ll try the steps and report back Well, the OpenBuildsCONTROL update is very unlikely to be the...
Hello My machine has been idle for a bit, I determined I was asking too much out of the 1605 ball screws for speed, so ordered and waited for the...
Voltage is maxed out on the X. speed and acceleration indicated above. Increased Y slightly to get the motors slightly warm, same with X...
Peter, but to your point. Just dropped it down to 1200 and can't stall it by finger pressure alone. I'll put axis back together and re-test....
Acceleration is at 150. For speed I'm at to 2000. Sorry I'm not identifying units, but out of the box on Control. I'll go check now. On the...
I can't seem to edit the title of post below so reposting for assistance with better title. My X-Axis is basically stopping/stalling during...
Thanks guys, got some time tonight to troubleshoot. I will say I can run the axis with a drill at high speed with not issue. And with the screw...
Hello finally got some life in the machine. All built on 1500 c beams. 1605 ball screws. Open Builds box and high torque motors. see video....
Well, just tried the last thing, THE 4 PLUG CONNECTOR! That was it, not sure which one, but swapped out the plastic 4-prong plugs from another...
Well. Was hoping I'd self correct but hitting a wall. To date I have: Replaced the wire, re-terminated all connections, no change. Ran it on my...
Thanks Peter. I’ll go through that connection again. Replace wire. Might have a couple extra 4-pin connectors too. It was nothing obvious. But...
Hello Certainly tried to help myself with searches, but out of ideas. Had been running my old workbee without issue, that went to a friend and...
Okay. Figured a mount for standard open builds switch! Hope to have first movements in a few weeks.
Peter. See above. Open Builds instructions are very clear. I’d like to use this switch for the Z. Just because it fits well. but the...
[ATTACH]
Hello upgrading Z. Unit comes with a different switch. Wondering if folks know what the conversion is. Switch is marked normally open...
Hello Almost done with my custom machine. But it’s built around the C extrusion. So not totally wild. Using the black box and high torque...
