Separate names with a comma.
Some features disabled for guests. Register Today.
the stock GRBL post uses G28 which requires a bunch of knowl;edge to work correctly the openbuilds GRBL post uses G53, which only requires homing...
when control asks the Blackbox who it is, the BB is telling it that it has an A axis. so, either it is lying, ie a USB communication error, turn...
well, it is stuck hard on something, you rmission is to find out what and remove it (-:
clean the machine so you can see what is making it stick. debris under the wheels can easily cause sticking like that. with power off, can you...
ok, but with GRBL in laser mode then M4 will ramp the PWM as the motion speed ramps, not what you want for plasma (-: look sliek anice machine...
I have tried this on a bare Uno and now again on a BlackBox 4X with GRBL 1.1f loaded via OpenBuildsCONTROL (and just tried it with the X32 with...
you must power cycle the Teensy after changing that parameter
maybe you flashed the ACRO XY only firmware?
what 2022 Darwin should have done is create metadata, data about the data (-: I use README files, put the gcode into a folder and a README file...
yes there is such a setting, and the default for OpenBuilds profiles loaded to a Blackbox is 'always on' , I wonder what changed it? (might...
no, Gcode is relative to the WCS origin that you set in the 'setup' in Fusion. WCS = Workpiece Coordinate System The WCS is relative to the MCS...
what have you drawn in fusion? a sketch rectangle the size of your spoilboard? that is probably bigger than your actual limits, so if you just...
cyclic stiffness is an off center pulley not the bearings, they will outlive us all unless you pour sand in them
there is an M code for it, read all about it here M-Codes but you will need something other than CONTROL, I recommend bCNC GitHub -...
[MEDIA]
DO NOT push the carriages around by hand unless you have disconnected the motors from the drivers (with power off). cyclic stiffness may be due...
just wire it to ground and signal. you should see it connect in the troubleshooter when you touch the body with the magnet. if it stays...
what you need is an Interface, that will allow both direct control and wifi control of your machine INTERFACE CNC Touch
fixed it, so jump over to GitHub - OpenBuilds/OpenBuilds-Fusion360-Postprocessor: Post Processor for Fusion 360 for use with OpenBuilds Machines...
clearly a problem there, the holes are not drilled, I will debug over the weekend but this is confusing because this is not using a center drill...
