Separate names with a comma.
Some features disabled for guests. Register Today.
the link i found for the machine says it has nema34 motors which are bigger than nema23 = more power. that is why I suggest the high torque motors...
I think you want to swap in the high torque motors which will work nicely
why do you think a standard openbuilds bracket will not work? Hardware - Components - Page 1 - OpenBuilds Part Store
you are putting the collet into the nut (must click into the retainer ring) before putting the bit into the collet, right?
simple, you are trying to go too fast slow down the max rate settings till it works reliably
I like to scribble all over the outside of the collet with an ordinary pencil (especially with those funky custom collets on cheap routers)....
This explains how to set your origin for the WCS [MEDIA]
and you have watched these... right? [MEDIA] [MEDIA]
I take it you mean in Fusion360? The OB post already inserts a bunch of info about the job, but not as 'variables' because GRBL does not...
so you have 2 pins on the centerline of the material, in the X axis ------------------ Y+ | 0 0 | ------------------ Y- then...
2 sided work is most easily done by incorporating 2 holes on the centerline, can be in either X or Y, I find Y easiest. these 2 holes are in the...
I have published a new version of the postprocessor, get it from github then watch this video [MEDIA]
rule of thumb for electronics: never use more than 80% of the numbers on the label. so the VFD is too small to run 4kw. a 4.5KW vfd would be much...
there are so many reasons why that can be...... from the drawing itself to the setup and the operations in it, everything matters. I have...
the interface screen shows WORK coordinates, which will be relative to where ever you last setZero (which is relative to home). maybe this will help.
are these specific distances ones you use often? then define a macro for it. or perhaps you need a probe and macros to drive it so you don't...
first, load the ftdi drivers docs:blackbox-x32:install-drivers [OpenBuilds Documentation]
That movement is given to you by the jog buttons, or by direct commands in the serial console, or by macros that you create to do what you need....
I think your PC is not grounded, check with voltmeter for AC between PC case and ground pin on AC plug.
seems to me at least Y is going in the wrong direction. 1. turn off homing 2. make sure the tool jogs in the correct directions, X+ is tool...
