Separate names with a comma.
Some features disabled for guests. Register Today.
you can create Gcode macros for OpenBuildsCONTROL you can move in absulute mode (the default) G21 G90 G0 Y100 moves to the position 100mm from...
you mean the 2 Y's are running in opposite directions. the cause is that one is wired backwards, for leadscrews they must both be the same. this...
what are the max rate and acceleration settings?
yes you can
what do you want to measure? total on-time or spindle on-time?
what noise doe sit make instead of moving?
and don't forget the instructions at OpenBuilds-Fusion360-Postprocessor/README-plasma.md at master ยท OpenBuilds/OpenBuilds-Fusion360-Postprocessor
How are you generating the Gcode? if you are writing it by hand, don't, CAM does a much better job as it is already debugged (-: most CAM...
contact the store ....
you can use ChatGPT to translate... (using it to transdlate our English to French may help you understand better too)...
ah, i see now.
also, on this page docs:interface:firmware-update-wifi [OpenBuilds Documentation] I see 3 ways to update the firmware and only one of them...
no, your machine has backlash, lots of it. this means that when a motor turns the carriage does not follow it exactly because of 'soemthing...
you have confused a few things... (or maybe it is me :) ) the BlackBox X32 is a controller and though it takes a SD card it does not need a...
I would turn down the maxrate and acceleration and then run the calibration wizard note that the math is simple and explained in various...
backup all your settings then try it and see. (-: or you can reduce the max speed of that axis, which will reduce the kernel speed requirement...
hard limit and homing <> soft limits turn on homing turn off soft limits
or 1 nema23 motor and belt all 4 leadscrews together no programming needed, just connect the 'dir' pin from all 2 (4) drivers to the DIR output...
you need a laser module from the store Lasers - OpenBuilds Part Store (follow the links there to the instructions) plus cables to connect it to...
iirc the shield has jumpers to pair x or y to the 4th driver
