Separate names with a comma.
Some features disabled for guests. Register Today.
that is exactly the thing that will fail at high step rates (-: at least, I could not drive RGB LED strings through one of those at 800kHz. so,...
That would be because the X32 post does not support laser and plasma, only milling. The X32 post exists to handle 4th axis milling, for normal 3...
according to that inputs are 4.5 to 5.5v, so 3.3 probably not enough to drive the direction signal but is driving the step signal. You will need...
I have seen several youtube videos about this. I woudl recommend NOT doing it by muscle power alone, but use gas struts or pulleys etc to make the...
to cut 1um off a bit of titanium probably does not take a lot of power, can maybe scrape that off with a fingernail?. to spin a leadscrew that...
no, OpenBuildsCONTROL is GUI software, it runs on a PC, and sends the Gcode to the BlackBox via a USB cable. With a BlackBox X32, it can also...
no need to measure it, just use the flattening wizard to cut it flat (-:
so the calibration is correct, but the jog is not? stepped or continuous jog? at what speed is the jog? set it slow, what result? set it fast,...
needs more triangles, triangles are strong (-:
you don't need a starting point other than what you already have, it is possible to calibrate a completely unknown system.... do not use jogging...
do not trust anyones wire colors, instead, find out for yourself which wires are pairs on the motors, and then wire the pairs. the documentation...
not just possible but REQUIRED as a step in the normal setup of a machine (-: That is why there is a calibration wizard in OpenBuildSCONTROL...
that is an empty box, not going to interface to anything like that. should be possible to hook up all the buttons etc to a RPi or other computer...
yes. end of file 1 will retract beginning of file 2 will position to same place, plunge to Z depth at plunge rate and continue. late last night...
Dropped a new post version last night, v1.0.37 This includes a tape splitting feature that allows you to set a line limit, gcode files will be...
i cant read the labels in your photo, too small. but at least one of those pins in a signal ground, use that. I don't know if the BBx32...
MArlin has runtime settings for steps/mm and aceleration, you wil need to read the Marlin wiki
your max speeds are too high. default zsfo rlLEAD machines are [14:30:46] [ $$ ] $110=2500.000 ;X-axis maximum rate, mm/min [14:30:46] [ $$ ]...
to the signal ground in that same set of pins, NOT the ground that the 24v psu uses
no, do not connect the PSU ground to the signal ground you need 3 wires from the controller to the pulse and direction inputs on the driver GND...
