Separate names with a comma.
Some features disabled for guests. Register Today.
to prevent the galling you can - spray with kerosene or WD40 - rub wax candle into the groove after each pass, ready for the next pass - spray...
the OB post can do it too, you have to change a setting to enable YZ and XZ planes, off by default. CONTROL cannot display the vertical arcs so...
I just use whatever web calculator comes up in google when I search for it (-: (or the tools settings in Fusion360 which will calculate when you...
need to be throwing chips like at 0:57 in [MEDIA] but then he spoils it all by not vaccuming the chips out
inches. I get 4500mm/min feedrate for a 2 flute, 2200 for single flute , so 18000 rpm may be too high, or you can go for 0.0025" per tooth...
this means your emergency switch is not doing what it is supposed to do. The emergency stop MUST cut power to the router and laser and BB. After...
I would try something like 0.040" deep, 0.005" per tooth, 18000rpm you CAM can calculate a feedrate from the rpm and per tooth values
grblHAL on PiPico, I think that has enough pins for what you want.
both those types of endmill have trouble ejecting the chips, which is probably why it is jamming up and stalling. an upcut single flute is what...
plenty of suppliers in Australia, use the OB page to figure out what you want, then look for it in-country.
@Peter Van Der Walt
ok, power switch not working, and motors not powering up, and you did load a profile from CONTROL. I think it is time you contacted the store for...
what controller is it Ian? for a Blackbox 4x and an X32 the $4 setting is different.
um, the bits in the picture are DRILL Bits, not milling bits. they are not designed to cut sideways at all, ever. you need some like these CNC...
does the Genmitsu controller run standard GRBL 1.1? if not then CONTROL will not work, but bCNC might.
once you have fixed the wiring, if you still have no movement, change the max rate and acceleration settings to half of the existing values and...
just load the settings, only erase eeprom when you have proof that you need to.
cannot see anything wrong with the Gcode, but I do see that the post version is 1.0.32, the latest is 1.0.36, please upgrade so we are all using...
not the bluepill, the PiPico, responds like this [15:57:41] [ 3D Viewer ] WebGL Support found! success: this application will work optimally on...
will try it again and see...
