Separate names with a comma.
Some features disabled for guests. Register Today.
did you also set the origin to the center of the work? centering the carving on the material is probably not the only thing you have to do....
you are resetting the BB after changing parameters, right?
I don't know, you will have to read the the wiki GitHub - grblHAL/ESP32: grblHAL driver for ESP32
Yes, appears as COM7
I tried this out, used the web builder to build for the pico using the -BOB-G540 option and got bCNC to connect. it does come up in ALARM mode ,...
do the calibration over a long distance, not just the default 100mm so if you can do 1000mm (or a yard) then use that. if you still come up wrong,...
does Masso have forums? if they do then that is the place to ask about solving your TCP problem
or this?...
you mean something liek this? Doughty Drive The 4th & 5th Axis solution there is a belt between the motor and the axis. The motor bearings are...
I have noticed (-: Please confirm you have read and followed this OpenBuilds-Fusion360-Postprocessor/README-plasma.md at master ยท...
the critical thing that a controller does is to SYNCHRONIZE motion across all axes, they must move is unison to achieve the programmed cut...
but it really should be an option in lightburn rather than manually editing code every time
thanks, then you can compile grblHAL for that board, there is already a pin definition for it http://svn.io-engineering.com:8080/ I think that...
that'll work. correct, I use no endstops or any other frills except a Z probe, which I did not connect to this controller since it was for...
1.1h is the last GRBL version, and I see no indications it is running grblHAL even though the board has an ESP32 processor also not seeing the...
perhaps if you post more information about what you do have , specifications and photos, then someone will recongize it and help you.
I believe you flash the 3 axis firmware and then change some settings to prevent it trying to home Z ah yes, BlackBox X32 and Additional or...
peter, do you have a list of the options to pick for a stock X32 build? I'd like to document it as a resource....
lets keep this simple, the BBx32 will run your machine, but because it cannot supply 7amps (and since your drivers are much bigger I would expect...
that could be play in the spindle bearings, when you probe the Z height the spindle has to push hard enough on the probe block to make electrical...
