Separate names with a comma.
Some features disabled for guests. Register Today.
I don't think it will be supported , there are much better chips already supported by grblHAL (such as the ESP32 in the Blackbox x32).
check the settings for the toolpaths in the drawing software, nothing changed in the machine between the 1st and 2nd part, so it must be in the...
check the limit switch mounting, it is possible to mount it such that the pins or other bitson the circuit board are shorted to the frame, this is...
I believe this what you need to do docs:interface:device-test-mode [OpenBuilds Documentation]
You don't say what controller you are using but lets assume a Blackbox type runnig GRBL. GRBL understands G28 as a 'go to stored position'....
@Jeffrey A Melius have you had a chance to try it out?
the dejavu is strong with this topic, I am sure I typed this out just the other day.... somewhere.... it looks like Vcarve has formulas in it...
have you calibrated the Interfaces buttons? do all the anti EMI stuff in the documentation? EMI can afffect the touch sensitive buttons on the...
to clarify for the original poster...... the microprocessor in the Blackbox X32 is 32 bit. it runs grblHAL, which is compiled for that...
I dont know how to do that, perhaps the Mach3 forums/documentation will answer that? Machsupport Forum - Index
I think you also need to tell Mach3 to pair Y and A to make them move together
Hiya tried to build with this included and got Command failed: pio run -etest -cjob.ini [notice] A new release of pip is available: 23.0.1 ->...
the other way is to send a long jog command while the key/joystick is pressed and a 'stop jog' when it is released. This is how CONTROL does it in...
something is TOO loose for sure, 'not that loose' is probably too loose for your depth of cut. how sharp is the bit? is it clean? they gummy...
check all motor connections, especially Y2, and by check I mean unplug, pull/wiggle the wire in the plug and physically make sure all is properly...
seems like you are not getting a successful homing. in the GRBL settings turn homing off and reset the xpro now you should be able to jog around....
why does the bike lift safety instruction include 'do not use during thunderstorms'.... what? <-:
how about this [MEDIA]
if there is no setting, then you dont need it (-: exact radius of cutter will apply mostly to finishing cuts, for which a morphed spiral is not used.
GRBL firmware cannot do this, you have to do it in the GUI software (CONTROL/bCNC/UGS etc). In CONTROL, you can write a macro that will do your...
