Separate names with a comma.
Some features disabled for guests. Register Today.
that is normal for some RC servos, though nearly 180 is a bit more common.
yes, you will have to process the dxf's. quite simple with cam.openbuilds.com (-:
ya, that is not even Gcode as I know it (-: you or they will have to use a GRBL postprocessor to generate the correct gcode.
and the controller will have proximity and motion sensors so the motion is triggered by someone stepping near (motion sensor), and speed is...
clear indication of backlash in Y I think. think about what direction the rotating bit is trying to move vs the direction the machine is trying...
you don't have to be very good (-: just visit Issues · OpenBuilds/OpenBuilds-CONTROL and click the 'new issue' button, birght green, right hand...
you do know that you get Z control OR servo control, but not both at the same tiome, so to swap between them you have to reflash.
probably possible, yes. special soffware required, yes (for generating or modifying Gcode). advisable, no. too much can go so wrong (-: fun to...
GRBL has been like this for 15+ years (-: nope, no such setting unless that compile option does it, I have never messed with any of those...
there is no reason to use Windows7. if your hardware cannot handle Windows 10, or there is some other reasons you cannot use windows 10 or 11,...
with GRBL's servo control it will always move the servo to whichever end is PWM level 0 when an M5 is received. (common at the end of gcode...
you do realize that the BB X32 was released just a few months back, along with software to support it (on pc and Interface), and the Fusion360...
in CONTROL use the troubleshooting page to check that the switches correctly trigger AND trigger the correct axis. [ATTACH] ignore my probe...
the web integration is used to send generated gcode from cam.openbuilds.com direct to CONTROL, but for this to work CONTROL has to be loaded....
searching shows instructions for this at (not a Mac man myself...) Probing sequence won't move anything
turn homing off make sure jogging on each axis goes in the correct direction. +X is tool to the right, Y+ is tool away from you, +Z is tool up...
on a Mac? known python path problem
get yourself an ACRO kit and laser etch onto the paper. hang it on the wall to save space (-:
just scribble on the outside of the collet with a soft lead pencil
You need to update the firmware in the X32. Use OpenbuildsCONTROL to do it.
