Separate names with a comma.
Some features disabled for guests. Register Today.
if you want rigidity then I believe you need 2 clamps holding that router. I ran mine for a while with a single clamp (holding a Dremel) and could...
[MEDIA]
you want to be producing chips instead of dust. so 180ipm at 10000RPM for 0.01" per tooth on a 2 flute or 100IPM at 10000RPM on a single flute for...
do make sure your defined positions have Z as high as possible without triggering the limit switch. you do not want a rapid goto to dive Z down...
I would try the cheapest *thin* superglue from a dollar store, it will soak into the paper and set instantly, turning it into a paper/plastic...
Do not use R format, only I J K format for arcs. While R will work most of the time, there will be times when it does not work and will try to do...
I would not bother. I spent a week drilling and fitting blind nuts and never used them and have since replaced that spoil board. a) the masking...
you can change the default extension that Sketchucam uses: no surprise, it is in the user manual (-: SketchUcam: HOWTO set default options which...
don't forget to reset the blackbox after changing the steps/mm numbers. my process is to go back to 0, then hard reset, then run the calibration...
you can use GRBL settings calculator to get initial numbers for the belts, but then do at least 2 calibration cycles
SketchUcam does not output DXF files, it outputs Gcode. SketchUcam has never used the 'save as type' mechanism, you click the big green arrow in...
no math needed, just use the wizard in OBControl (-: but if you really need the math, go here
Update to the latest release, this should do what you need Release V1.0.31 · OpenBuilds/OpenBuilds-Fusion360-Postprocessor
there is also a Resource for this, which explains all the math HOWTO Calibrate your CNC Machine for MACH3 or GRBL
if you run OBControl with the old controller connected and do a settings backup, disconnect that, connect the BB, and restore the backup, should...
are both posts cutting in the same direction? this can affect outline sizes. maybe the new post is obeying a 'radial stock to leave' setting...
did you select 'LASER: Use Z motions at start and end.' in the post options? This applies to PLASMA as well. in your gcode: (Made in : Autodesk...
i don't see a problem in that small fuzzy image (-: so long as you select everything and then scale it all together it should be fine, otherwise...
do you mean you are importing a DXF into Openbuilds CAM? if so the scale function should fix it 16" = 406.4mm so you need to scale up by 25.4 to...
