Separate names with a comma.
Some features disabled for guests. Register Today.
how about thicker wires that can carry the current without getting hot?
first read all of the XPro v5 wiki at Home · Spark-Concepts/xPro-V5 Wiki particularly the sections on hard and soft limits.
With everything switched off, take good photos of the motor connections on the drivers. Gently move each motor by hand, noting the feel and...
'Gerbl' is you might say it, 'GRBL' is the actual software (-: read all about it here Home · gnea/grbl Wiki What does this involve? remove the...
so the room is 10C, is dew condensing? condensation will definitely affect capacitive buttons.
I feel our communication has become a little warped somewhere along here (-: The dialout group exists by default Members of the group can use...
Thankyou I was right, that -4mm Z plunge on the finishing is a problem because the roughing did not cut the shape out to the edge, only to the...
Does it do this in the same place every time?
I believe your Z axis is losing steps, or maybe a shaft coupler is slipping. Check the shaft coupler to make sure 1 of the screws is firmly...
The Blackbox has stepper motor drivers, you have servo motors with their own drivers. If those servo drivers have "step and direction" inputs,...
Yes, but it depends on your actual machine step size, ie, how far does X/Y move for 1 motor step? That has to be <= half of the 0.025mm tolerance...
or you might read the instructions on the bCNC Wiki (-: Installation · vlachoudis/bCNC Wiki
So you are relying on a connection through the greased bearings of the spindle, right? Clearly this is not a good connection, causing probe...
a particular file or any file?
Hi how about putting the radio on a stool and attaching 24" dowels to the sticks. now, instead of using finger movements you can use arm...
The Blackbox runs GRBL firmware. GRBL supports the simplest subset of Gcodes, documented in the wiki (you should read that whole wiki, knowledge...
please read all of this docs:interface:start [OpenBuilds Documentation]
I would avoid the jog commands You need to set up a gcode file with a long string of repeated 'go right, go left, go right, go left' commands G21...
why are you sending 'connect' ? that does not exist anywhere in the GRBL wiki, and is not part of the Gcode standard either. "G0-F200-X10" will...
no such thing as 'over built' there is only 'built correctly' and 'not built strong enough' (-:
