Separate names with a comma.
Some features disabled for guests. Register Today.
Davey Rance submitted a new resource: C-Beam 250mm Step File - C-Beam created in Fusion 360 length 250mm Model of 250 mm c-beam as solid. Read...
Modeled the 250 mm c-beam
Mark i say that would be fantastic having the bits cut by default would be fantastic. I am going to be using a spare Ridgid R2400 that i have had...
For those that are looking for a way to cut the vslot by hand for there first build i found this build this morning....
Mark if possible i would like to take you up on the offer to cut the 60x20. I have also ordered the extra 6x20 just that way i have some to play...
Thanks Mark. I replied to the email and will get the couple of extra 20x60 and i can then trim / cut to size. If i get it wrong i will then have...
Motopreserve check out http://www.selene.co/Blog/2011/07/stepper-motor-voltages-explained/ this gives a good idea about voltages and stepper...
Motopreserve worst case is the steppers may skip if the PS cant supply enough. But you can as a general rule over voltage steppers as they run at...
Motopreserve it should be fine. The steppers are rated about 2.5 A each at 24 V so even allowing for any extra that would be a max of 10 A or so....
Yep Rick i had seen that but thought that it would be worth while asking anyway :). Wasnt sure how much rigidity would be lost by using a couple...
Mark i have one of the C-Beam Machines's on order but i dont trust myself in making clean square cuts for the vertical lengths. Would it be a bad...
Making that higher voltage out of PC power supplys may not be your best bet. Each only gives out 12 v so you would have to put 4 in series. Ebay...
For fusion 360 watch this youtube video as they import bits in there [MEDIA]
