Separate names with a comma.
Some features disabled for guests. Register Today.
$N0=M8 works, thanks!
A few questions; Is there a way in Openbuilds Control to run gcode commands 'on connect', 'before start job', 'after start job' ?For example,...
I'm experiencing an issue with the flattening wizzard... or rather with the tool. When the tool passes from right to left, there is zero 'bump' ,...
Carveco; grbl post. But i noticed i had a tiiiiiiiny stepover, which generated an enormous toolpath, (which ran just fine without the renderer...
Forcing the high performance GPU didnt seem to do much, although the diagnostics says it is in use. See the enclosed file. Without the renderer...
I have an issue with a large gCode file i want to load. It is an intricate shield design i found on thingiverse. I succesfully created a carve on...
@Glen.G @Peter Van Der Walt I ran into the same issue and managed to resolve it together with RatRig staff; Thing is; the documentation is a...
Stupid question, but did you swap the plugs when you swapped the controller from xpro to openbuilds? They _seem_ the same, but after someone...
Seems I was a bit overwhelmed with too many open tabs looking for the right settings. Thanks for your quick replies
Thanks for the quick reply, I can work with that. it seems like you answered while i editted and added question 4; "how can i set / check the...
Just setting up my X32 controller after switching from another brand of controller (and it seems like @Shell M. Shrader has done exactly the same...
