Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks MG, Its starting to make sense after your explanation. I have downloaded GRBL panel but not used it, just a little nervous of it as it...
Thanks for the time guys, appreciated! This is the gcode I am sending: % (Generated by SketchUcam V1.4d-80c0152) (File: cncdustcollector.skp)...
Hi, I am working in metric. to be fair I mainly use the basic Universal Gcode sender which is in Metric but I didnt realise Ugs was in inches. is...
I have just looked at gcode parameters and it is showing (G54:-6.000,--6.000,-1.000), is this correct as all the other G commands are 0.?
Sorry, I may be confusing you, it will home to the correct position and it will return to zero wherever I set it, but once I have set Zero (where...
It shows G10 but not G92. Cheers
Ugs resets to zero. I will check the G92 and G10 as not sure.
Still get the same result I'm afraid. Odd one I know.
I click reset zero in Universal Gcode sender when in work area position.
Pulling my hair out at the moment, can someone here save me from death by alcohol?. My Ox is built, has taken 6 weeks on and off, I found the...
Thanks Rick, never wired resistors so its great to get confirmation.
Hi Guru's out there I have purchased 4 x MB450A stepper drivers. They turned up with what I think is resistors (out of my comfort zone with...
Good point Rick 2.0
Ahh ok, that makes sense, thanks.
Thanks Giarc, I am out of my comfort zone with electrics as you can tell and have spent so long building the Cnc that I have mentally hit the...
Well that clears that up, I have obviously overlooked that another bit of kit is needed, in fact 4 bits of kit, oh dear. Thanks for the spot...
I have recently purchased an HG08 breakout board which connects to a U300 motion controller to run my newly built Ox cnc. I am a woodworker and a...
A long time since but just wondered how you are getting on with the U300 and HG08. I have just ordered the same setup.
Thanks all of you for the above, will try all these suggestions. The drag chains I ordered turned up today so I am in the process of tidying up...
Can't thank you enough Giarc. Not boring at all, this is a great help to me. I got so involved with the build I almost forgot why I was building...
