Separate names with a comma.
Some features disabled for guests. Register Today.
When i connect enable from BB32 to x1 vfd 0-10v to Vi1 vfd Gnd to gnd vfd Spindle spinning all the time even if Bb off and usb disconnected then...
I followed this page Its just changing Hz in the vfd but not run spindle
How to check it I have same vfd but would like to check
Finally, smooth movement Thank you again, and forgive me if i was noisy
[ATTACH] Ok easy to fix Solder failed :D:D Need to redo it , fan/case top pressing the solder thank you gentlemen, will come back with the next...
Ok thank so much Will search abou what you said
[ATTACH] Here 3.3-5 haha that’s why I bought it, will have a look at level shifter , thank you Peter
Yes both exactly same act manual said 3.3-5v
@Peter Van Der Walt @David the swarfer
Just connected everything, y1&y2 move very quite and smoothly but the moving only one direction which is negative direction Turned off then...
Thank you @Peter Van Der Walt @David the swarfer Yes i can see clearly GND pin above X DIR will solder wire to it Just thought i can use any GND...
I'm l sorry for my dumb questions I can solder to ground pin, i cant use for example door ground, limit switch/ toolhead ground? [ATTACH]...
So pul- and dir- go to ANY ground in the blackbox ?
And is better to parallel signals for 2 drivers, use one bigger driver for Y1Y2 motors or just use original BB32 driver for Y1 motor and extrnal...
Just sent to electronic guy and soldered [ATTACH] Then for driver side (DQ542ma maybe) Will just connect step to PUL , direction to DIR And...
Ohh thank you , will see now :D
what i see is they are same but I know I’m not smart enough [ATTACH]
[ATTACH] Hi A know this is too old but just feel better to ask here not in new post, sorry if you don’t prefer this I can see header on the the...
just discovered something easy and useful Open gcode in Visual Studio Code or notepad Then replace all Y to A 30 second to do that
