Separate names with a comma.
Some features disabled for guests. Register Today.
Totally great advice. Changing my bit to a 3.15m (it's actually 3.17, aka: 1/8th, using the above-mentioned end mill size test) and running 3...
Images of the Caliper
Hm. Now I'm stumped. Adjusted the program to a 3.15 endmill and reran - worked, with reservations. I have since remeasured it using the thick...
Measured it in fractions at 1/8, measured at 3.15mm, which is slightly smaller. Running a few tests right now.... 0.125 = 3.175; so 3.15-3.175 =...
I'm having problems getting my circles to be the correct size. My program is telling my machine to go 7.2mm dia but the circles the CNC is making...
My xpro was the v3 model, the wires were directly wired to the board. So I completely unwired everything.
Turned CNC on before adjusting anything, Y failed within 2 min of just sitting there. Swapped Y2 and Y; Y again failed in 2 min. That ruled out...
Fan on the Blackbox is spinning and is moving air quite nicely. The PSU also sits inside a box that has 2 server-fans pulling cool air across it...
I didn't reterminate any of my connections and I had previously soldered on micro terminals (see pic above). After I inserted them, each one was...
Note, I did confirm above, but here is the PSU.
Yes, using my original 2017 build and just swapping out the controller and adding in an interface. The PSU is a meanwell LRS-350-24. I will...
You think it might be a current problem? Interesting, as I was just reading that page and another post about adjusting the potentiometer. A bit...
Just set up my new X32 controller and interface. Both are running the latest firmware. I am getting a random Y motor failure. So far, my...
Name: openbuildscontrol.exe From: Unknown Version: Copyright: Detected Resource or Process ID:...
Is it just me, or does this light up anyone else's AntiVirus products? First it blocked it due to ransomware, then it didn't like the file...
Take my money already:thumbsup:. Can we pre order to reserve one? How about getting the case stl so we can start milling?
I'm assuming your using NEMA 23 stepper motors? What spacers (specifically) did you use between the stepper motor and the brackets? Thanks
