Separate names with a comma.
Some features disabled for guests. Register Today.
So Peter what was up with the ring of wires/iron ring coil on my old setup? Was that meant to be an EFI filter? Why don’t the new VFDs spec this...
For sure. I am coming from the ShopBot world, when I pause their machines, the code stops, the bit lifts 1" off from the workpiece and the Spindle...
So to make sure I understand you correctly - you would wire a switch into the mains 110V that feed the VFD?
This is a big factor for me because when I pause a 13 hour 3-D finishing cut, I need to be able to turn the spindle off overnight and restart in...
Peter – if I wanted to put in a safety switch to be able to turn the spindle off manually, would I wire the switch into the 0 to 10 V wire coming...
There is continuity between pin #4 on my Spindle and the outer case of the spindle housing. I don’t like the fact that the Huanyang spindle...
Also I have another follow up question: my old VFD came with this card instructing the installing engineer to loop the three UVM cables from the...
Josh how come you specify PD144 = 3,000? Shouldn’t that be 24,000 (Pd144 in the Huanyang manual is “Rated Motor Revolution”. Edit: also, and...
@Peter Van Der Walt what are your thoughts on adding a dedicated ground wire to the #4 pin on the spindle? Should I plan to run this ground wire...
Understood completely. I already texted my electrician friend to come over after work tomorrow to look at what I've got going on....
Indeed.
Duly noted. In the interest of learning, what comes out of the UV and M terminals? I would like to deepen my understanding of how the VFD controls...
Can’t see how that would have changed… As far as further bench testing with a digital multimeter…what should I see from the UVM terminals with...
Also I do have a spare spindle motor that is brand new replacement of the exact one on my machine. I was reluctant to wire it up until I can...
The manual that I have is photocopied and in poorly translated Mandarin, of course. I think it says Err02 = Acceleration Overcurrent (possible...
Hi guys. My 10 year old secondhand RATTM MK100 motor VFD suddenly decelerated the bit and started throwing error codes mid-cut yesterday, so I...
Hey guys wanted to say thanks for these suggestions. My machine has been reconfigured per Ricks design and is back up and running. It is much...
This is the code: M8 M3S1000 G4S120 M3S5000 G4S120 M3S8000 G4S120 M3S10000 G4S120 M3S180000 M5 M9 The Interface powers up the spindle and...
Sun
Well, that is a shame, the reason I got interface was to run these long carves so I don’t have to leave a computer running them. The pause method...
