Separate names with a comma.
Some features disabled for guests. Register Today.
I just noted this on the fusion Gcode......will it make a difference? how do I change that to the current version? Of course this was all...
I'm sorry, I misread your reply. I am new to this so I am not sure either. It seemed to work before
Yes G53 G0 Z-10 is in there
I have reloaded and reset the controller with the Gcode and 0 axis points twice to see if it was corrupted settings, connected and disconnected...
Tool path has no errors [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Check out my heights on fusion
Yes, it is up & down as normal. I thought of that. I thought maybe the axis was flipped. It sure acts like it.. It used to raise the machine to...
Here is the file in 2 formats. Whay was it working and then not?
First off I would like to thank all of you for your patience and expertise. This is a challenging but fun learning experience. #1 I noticed that...
Thanks, I will let you know how it goes.
sorry, wrong file....How do I update?
Reset did not help
V 1.1.170....Here is the most recent version. I am trying to make it look better
so, I have used your method and it helped. Thanks. Now I have another issue. When I load the Gcode it places it in a funny location.
no. I ran it once before from 0 and it didn't do this. So I should be raising the Z after I set the 0 point?
so I tried my program out again and now when I start the run command from 0, it runs through the face of the board on its way to its 1st point....
I also shimmed the spoiler board. I can't figure out what happened. The plate is level and I used the same sized shims to place the MDF base, but...
I had to invert it. Otherwise I was getting a mirror image again
$0 Step pulse time, 10 microseconds µs $1 Step idle delay,255 milliseconds ms $2 Step pulse invert $3 Step direction invert Invert X Direction...
Does this look right? $0Step pulse time, microseconds µs $1Step idle delay, milliseconds ms $2Step pulse invert$3Step direction invertInvert X...
