Separate names with a comma.
Some features disabled for guests. Register Today.
I know that people here build 3D printers but my PowerSpec 3D Pro 2 printer broke down due to bad heated build platform. I'm looking for a new 3D...
After watching the video above and another video at [MEDIA] , it almost worked but the Z-Axis isn't still perfectly trammed to the MDF board but...
After getting the Whiteside 1" CNC Spoilboard Surfacing bit, I ran the Surfacing Wizard in OpenBuild Control and found out that the bit isn't...
Go to "Troubleshooting" tab, touch the magnet and the plate together and the "Probe" light should change colors. If so, put the magnet on the...
Did you set Z zero before starting the job?
Check the wire going into the terminal that attaches to the magnet holder. I have the "puck" touch plate and the wire going into the clip broke...
What if the magnet isn't electrically conductive?
Put a thin flat screwdriver in the space between two bearings and push one out.
Go to "Job Setup" and see if the "Use Offset" is checked or not.
Before replacing couplings, check the collars next to bearings and see if they are tight.
Use 3D printer for small jobs and CNC router for large jobs. I'm in the process of building a model car from scratch using plywood for large parts...
I think that lead screws should be longer so that bearings and collars are outside the end plates instead of inside so that there will be no screw...
What about Kindle Books?
Has anyone try to calibrate their machine so that test square is exactly 100mm X 100mm X 5mm? I tried to do it as best as I can. What about this:...
Is it possible to use digital calipers to calibrate CNC router? I tried to calibrate my CNC router using a ruler but I can't see exactly where the...
I suggested that Openbuilds put bearings and collars outside of end plates like Ooznest did a few months ago. I bought new lead screws from...
Next time you create a toolpath, measure the thickness of the material and add 0.05mm. When creating toolpaths, Z zero should be at the top of the...
Will the XYZ probe work with XPro V3 board?
Did you make or buy the dust shoe shown in the image in the above post?
There is another way of finding pairs of wires: touch a pair of wires and try to turn the motor shaft. If the shaft won't turn, you found one pair...