Separate names with a comma.
Some features disabled for guests. Register Today.
You must have fixed the problem in build 1.0.205. After updating, the text box is now full width.
The textbox with the "DOS" prompt for entering GRBL commands below the Serial Console window.
The input box for entering GRBL commands is too small.
Peter, I sent an E-Mail message to http://support.openbuilds.com/support/home asking them if I can order custom-length lead screws and they said no.
I think that OpenBuilds should sell longer lead screws so that the bearings and lock collars are outside the end plates.
Are there stores in USA that sell 1100mm Tr8*8-2p (4 starts) lead screws?
I found out that one of the lead screws on one of the Y-AXIS were whipping on my modified LEAD CNC. How can I fix this problem? I'm not sure if I...
Is it possible modify the software so that 100mm travel distance can't be used on the Z-Axis? I broke a few bits because of the 100mm travel distance.
Is the 110/220 switch set to correct voltage for your country?
How do you use the 3-way switch with the IoT power strip?
Does the XPro V4 board has a power supply connected to 12V-24V input terminals?
What's the length of screws for spacers making the gantry plates stiffer?
Stepper motor drivers may be bad.
Did you measure your bits? Some bits are not exactly the size listed on the pack. For example, a 1/4" bit is really 0.24" instead of 0.25".
Even with the 3D View disabled, the software stopped responding a few times and I see "websocket disconnected" messages.
Is it possible for a new version of OpenBuilds Control Software that doesn't use websocket?
I don't use Fusion 360 but I use VCarve Pro. Go to Fusion 360: grbl post processor install (the easy way) and follow instructions on installing...
I'm not sure if you can lay the 20X80 beams that support wasteboard on their sides.
I don't see any wire inside the hose.
The vacuum hose is made from black flexible plastic (I think) and connected to the Shop Vac.