Separate names with a comma.
Some features disabled for guests. Register Today.
The third stepper motor driver went bad this morning. I had to order new one.
Where will the machine be put in the room? I suggest putting the machine in the center of the room (think kitchen island) so that you can around...
How do you suspend the router cable/cord over the machine? I suspend the vacuum hose over the machine using a spring.
Try updating the drivers for the GMA 3000 card.
It looks like ArtCAM is discontinued.
In the software that you use to create toolpaths, edit the toolpaths by selecting toolpaths not yet cut including the toolpath where the machine...
I have rebuilt the machine so that it's similar to the LEAD Machine. I think that the adapters should be made from aluminum.
In VCarve Pro, there is "Allowance Offset" in "Machine Vectors" in "2D Profile Toolpath". What is "Allowance Offset" for?
I thought that you're not supposed to run two motors off one driver.
I couldn't remember what the parts that go between bearings are called.
Did you put the washer between the bearings? Bearing - washer - bearing?
Try disabling "3D Preview System" and updating video drivers.
Did anyone get "WebGL support not found" messages? Try updating video drivers.
I measured the thickness of the material and added 0.05" to cut depth in VCarve. Why do USA and UK keep on using inch and foot measurement system?...
I was cutting out parts for a 3D turkey and found out that the cut was not deep enough. I click on "goto zero XYZ" button which displays either...
Don't buy it.
What if someone plugs a 110V device into 220V socket?
Is the 110/220 switch set correctly for your country?
The software "locking up" and stopping responding came back in version 1.0.198. I had to disable the whole 3D Viewer system. I tried to find older...
What does "Skybox" do?