Separate names with a comma.
Some features disabled for guests. Register Today.
I found out that VCarve 10.0 is released. Should I upgrade from VCarve Desktop 9.5 to VCarve Desktop 10 for $90 or to VCarve 10 Pro for $350? My...
I made some test cuts and found out that the slots are too short for tabs. I have to draw lines in center of rectangles and delete the rectangles....
I lied to VCarve Desktop that I'm using 2.9mm bit and after generating the toolpath, all the slots show up on the preview window.
I downloaded drawings for a model car that uses tab and slot construction. I have VCarve Desktop software and when generating tool paths, the...
I read the manual for an VFD and got confused on setting up the VFD. Most VFDs require 220V and both my house and the woodworking shop have 110V...
I know that there are two kinds of spindles with VFDs - air-cooled and water-cooled. Water-cooled spindles could be too much trouble because water...
The router on the CNC machine at the program for mentally-handicapped people won't run when I turn it on. I checked the brushes and found one...
I think that punching the shaft may bend the shaft.
2 spiral flutes on both 1/8" and 1/4" bits with 1/4" shanks.
Deep of cut is 3mm (1/8"). Plywood is about 12mm thick (1/2").
After I home my machine, I have to click on "Zero XYZ" button. After I use "Probe Z0" tool, I click on "Goto Zero XYZ" button before starting a job.
My feed speed is 60 inches/min. I'll try 30 inches/min.
Are there suggested feed speed for 1/8" bits on 1/2" plywood? I think the feed speed was too fast and broke a bit.
You can't use Mach4 to control xPro V3. You'll need Openbuilds Control Software that you can download from this website by clicking on "Software"...
Use "GRBL (mm)" postprocessor.
XHC MKX-V Mach3 Motion Control Card Breakout Board 2MHz Support Windows 7
Can you increase safe Z height? I think that there's not enough safe Z height if the rock/stone isn't flat. I think that the wiper motor doesn't...
[IMG] What kind of motor is this?
The bushings came today and they fit my machine perfectly (one was a little bit too tight). The hardest job was installing the two "hidden" screws...
I got camera streaming working between two tablets but I can't get it working between the tablet that has IP WebCam and computer running Windows 10.
