Separate names with a comma.
Some features disabled for guests. Register Today.
I searched the Internet for sealed limit switches and found some at...
The X-Axis carriage is the one that holds the spindle or router. Move that carriage so that it hits the 90 Degree Joining Plates before trying to...
Using the 90 Degree Joining Plates on top of the X-Axis gantry will limit the amount of travel that the X-Axis carriage can move. The carriage...
Are you sure that you didn't throw out all of the plastic wrapping without checking for parts. Openbuilds store does very good job packing stuff...
Cut out a 100mm X 100mm square piece. Use a digital caliper to measure the piece. If the piece is 99mm X 99mm, divide 100 by 99 to get 1.010101....
In VCarve's Tool Database, a 3mm endmill is set up so that it is 3mm diameter. I hope that you set up the 3mm endmill in ESTLCAM so that it is 3mm...
I don't think that drill motors with gearboxes work well for CNC routing. Router motors are better suited for CNC routing.
Did you tell ESTLCAM to use 3mm bit and did you tell ESTLCAM to cut outside the line for the whole piece and inside the line for the hole?
What software do you use to design the plywood tray handle?
What kind of connectors are these shown at Xtension Connectors ? I wish to buy them having at least 24 pins at other stores.
I watched the build video. Why not use Black Angle Corner Connector instead of Cast Corner Bracket or file the tabs off the Cast Corner Brackets?
How do I reset the XPro?
I watched some videos on calibrating CNC routers. I have GRBL Panel software and CNC XPro board. While calibrating my CNC router, I had to set the...
Download the Arduino IDE software and install it. This should install the USB driver.
I use "Go to Special Position 1" and "Go to Special Position 2" buttons for auto-zero probe. First button moves the Z-Axis down until the bit...
Bad news: On my machine at home, one of the onboard stepper motor drivers on the CNC XPRO board committed suicide while replacing the NEMA 17...
I connected the fan to the PSU and it ran so I cancelled the order for new fan. I think that the header on the board is for fans with three wires...
I found out that the fan cooling the board stopped running. I ordered a new fan. Should I connect it to the board or the PSU?
In GRBL Panel's Settings tab, Click "Enable keyboard arrows" so that you can use the keypad to jog the machine. I tried to use UGS Platform but I...
My machines has CNC XPro V3 boards. I tried to search the Internet to see if I can jog the machines using gamepad or keypad but I couldn't find...
