Separate names with a comma.
Some features disabled for guests. Register Today.
Can you see if the bit "bends" while cutting? If so, the bit is too long. Slow down the feed rate. If possible, use heated foam cutter.
I need double-tall gantry plates. I can't use gantry plate XL because it's too big.
I have some 1/8" upcut router bits but they sometimes cause problems such as rough cuts on 1/4" plywood and can throw pieces being cut off the...
I had to take my machine apart in order to adjust the Eccentric Spacers. I had to buy an ER11A 5mm Motor Shaft Collet Chuck Tool Holder and some...
I watched the video. The first line of code works but the second line of code doesn't work. I'm hearing-impaired and while the video has...
I tried to open the closed end of a 8mm wrench using a cutoff wheel on a Dremel tool but it's too thick. I may have to order C-Beam® Gantry Plate...
I ordered a touch plate so that I can have my CNC router do auto-zero instead of trying to use a piece of paper. How can I set up Auto-Zero using...
Do I need special wrenches to adjust the Eccentric Spacers inside C-Beams? I tried to use a regular wrench but I can't turn the Eccentric Spacers.
I wish that I can adjust the Eccentric Spacers on C-Beam Linear Actuators installed on my CNC router without having to take the machine apart.
I started cutting out a car puzzle from CNC Make website but the pieces won't fit into holes. How do I compensate (?) for bits smaller than actual...
I replaced the 3D-printed Z-Axis linear actuator with C-Beam linear actuator. I'm 3D-printing a pen holder. The spindle motor is controlled by CNC...
Search Internet using these keywords "mach 3 controller board". Avoid boards that use parallel ports.
Can you rebuild your machine to use C-Beam linear actuators?
I have read the manual shown at cnc-mill-guide [Smoothieware] but I'm afraid of soldering headers to the board because the pins are too close...
How can I set up SmoothieBoard 1.1 for use with a CNC router that has one stepper motor for X-Axis, two stepper motors for Y-Axis, one stepper...
WAIT! If you have different CNC machines, they must have their own profiles in the software that operate them. Mach3 software allows you to have...
I wish to build a 3D printer/CNC router combo machine. I ordered a SmoothieBoard, C-Beam 250mm linear actuator, and other parts. The machine will...
I built a CNC router shown at https://openbuilds.com/threads/my-new-cnc-router.11851/ I'm using 1/8" end mills/router bits. What are the best wood...
There is post processor for GRBL in latest versions of programs released by Vectrics. The post processor for G-Code adds code that's not...
As shown at https://openbuilds.com/builds/c-beam™-linear-actuator-build.1955/ , you can put two C-Beam Linear Actuators together to form simple XY...
