Separate names with a comma.
Some features disabled for guests. Register Today.
I added my vfd set up notes as a resource they can be found here; HY VFD AND BLACKBOX SET-UP OPTIONS
that-jim submitted a new resource: HY VFD AND BLACKBOX SET-UP OPTIONS - The options tried with my set up notes on the HY VFD and BlackBox...
HY VFD AND BLACKBOX SET-UP OPTIONS This document started out as my bench testing notes when I set up my 1.5kw 220v 2400rpm 400hz air cooled...
no worries, I am very glad to see that the resource is getting used. Your spindle mount looks very rigid, I bet it will work out really well.
Nice job machining that out of HDPE!
Sorry I was trying to be funny... I posted that probe holder file to the recourse page.
Jumpering between the DCM to FOR terminals is the source of the run command, given the the following settings PD001=1 this set the source of the...
That's a sweet looking probe holder.
yes it is interesting because I don't think it is all parameters just some. in the troubleshooting section of the manual it is mentioned on page 63
I looked at the image you posted of your parameters, you should check PD11, PD72 and PD73 PD011 = 0 Frequency lower limit. With external control...
I have recently set up a machine with VFD and spindle. One thing that tripped me up is that you cannot change some parameters if you are in the...
I found the answer in the Grbl-Esp32 wiki, Grbl-Esp32 has a setting for setting the value of the machine coordinate at the limit switch. So...
I am trying Openbuilds Control with a Grbl_Esp32 controller, just getting started but pretty much everything is working. The one problem I have...
Good quality ballscrews will be more accurate but the openbuilds lead screws are really very good and appropriate for a build like this. the lead...
I'm not sure how it would do surfacing al but i just mowed down a few threaded brass insets with a WHITESIDE 6210. And the surface finish on those...
I don't think that the nut for a 16mm ball screw will fit in the c-beam, perhaps if you build a custom nut block. The other consideration is the...
For this build I used the openbuilds c-beam and the 8mm lead screws with anti backlash nut blocks. C-Beam® Linear Rail Transmission - Lead...
Sorry if my post was not clear, the connection is in my second monitor. The monitor is connecting the dc ground to the ac equipment ground or...
I am working on placing my machine in an enclosure and have discovered that I have a ground loop between my control cabinet and my...
If the mini mill is your first machine turning it into a c-beam or something similar might be a good second build. That would give you a machine...
