Separate names with a comma.
Some features disabled for guests. Register Today.
This video shows the process of selecting the origin for your machining operations (WCS origin) [MEDIA] Remember you will need to regenerate any...
The SIM will usually look ok, because it is using the origin you have programmed. The problem comes when you set the machine to a different origin...
No worries - It looks like you have the origin set to a ‘stock box point’ this is OK, but you need to choose a point on the top of the stock if...
What’s on this tab; [ATTACH]
Already stated NPN
No, sorry!
The link I posted above to setting up the homing cycle walks you through setting up the limit switches too. Are your sensors NO or NC? Use the...
I don’t think you need to do anything to UGS, you just need to set up your grbl controller. Homing: Set up the Homing Cycle Set your machine...
No, the contents of the ‘Setup’ tab in that photo (sorry, I’m on my phone this week, so can’t show you where I mean). If you’re setting Z zero on...
Ok, that’s helpful - on the first tab of the ‘setup’ there is a section on WCS. Where have you set the Z height for the WCS origin for the CAM?...
Can you post a screen shot of your heights tab for the operation? What height is your CAM origin? (Top of stock? Top of part? Bottom of part, etc…)
What have you set your heights to in F360? Post a screen shot of the heights tab for the operation. Also, where have you set the CAM origin in F360?
You may need to set $5 depending on whether the switches are NO or NC. FWIW, I would enable homing and soft limits and leave hard limits alone.
[IMG] Just a thought: Probably the camera angle but it looks like both wires are connected to V+ (If not, it looks like they are connected the...
Supposed to be pn: :rolleyes:
Keep reading the wiki - it's already there (literally the next section to the one I linked to above). If probe or limit switches are triggered,...
The controller won't respond with 'OK' (or 'Error') until it has parsed the command and passed it to the queue in the 'look ahead' planning buffer...
Oops! Yes, MCS.
Have you read the section in the grbl wiki? Interfacing with Grbl
Yes, WCS Z0 should be at the very top of Z travel
