Separate names with a comma.
Some features disabled for guests. Register Today.
Here's the video I re-formatted. Pause video then click on the 3 dots (bottom right) and select "Zoom to fill". Run the video from the beginning...
I converted the video format so I could zoom right in and there is clearly plenty of movement in the X axis C-beam so something needs attention...
Can you confirm that it is not cutting a 6mm wide track in one direction then moving maybe 12mm on the X axis to start the next cut?
C Can you cut a rectangle, say 100mm x 100mm, then measure the width and height of the finished piece? Thanks.
Not likely to be a black box or UGS problem. How did you calibrate your machine? Do you measure the actual diameter of the bit before creating the...
A 6mm depth of cut is quite a heavy load - much more than I would consider for your typical router.
After you finish the probing, just jog the Z axis up to fit your boot - the Z axis will return to the correct position set in your gcode file...
you need better clamping too - one corner clamp is not a good idea.
Ok, didn't know that Peter - must be confusing it with some other problem (long time ago)
Can you open "Device manager" on your computer and scroll to "Ports" and locate the device your PC is connected to on your controller (for example...
Depth of cut is generally half the bit diameter or slightly lower. Your settings of 1/16" DOC @17k and 100" should work fine although the cut...
Puzzled by the terminology here. When you say bottom of the spoil board, do you mean the front of the machine? In any case, can you upload a video...
Yes, give Netfabb a try - I use it all the time where 3D p[rinting is concerned, Bear in mind though, it won't always fix everything but will give...
Yes, for the edges only. But, as I said, I didn't design it for that purpose, it was purely for allowing me to bore some holes down the left (or...
I designed an offset plate (some time ago) to mount on the Z axis which allowed the router to reach further into the sides of the spoil board....
Do you mean that when the carriage hits the switch, it pulls back from the switch, then contacts the switch again? If so, that's what it's...
Can we see an overall picture of the workpiece?
Peter, what effect does the Z axis acceleration =0.000 ($122) have ?
I don't see a lot of need for it myself, the lions share of the time is taken up just changing the tool - it only takes about three seconds to...
Kevin, it's not clear to me whether you have done this but... Remove the spindle (or router). Loosen the flexible coupling on the motor shaft so...
