Separate names with a comma.
Some features disabled for guests. Register Today.
What controller is on the machine? (OpenBuilds BlackBox?) What software are you using (For CAM and for Host?)
Great, so you can still consider one that can work with a single solenoid :) As support mentioned to you as well, there is only one output...
Not in a bad way. Will make it take proper effect Should only be relevant to soft limits
Is your $376 set correctly? (Should be $376=1)
You can "IF" the module has an optocoupler or other form of drive circuitry. Its only a logic signal (can't drive relay coil directly)
If you flash the 4-axes firmware from CONTROL > Wizards and tools > Firmware flashing tool > Machine Style > 4-Axes it enables the A-Axis buttons...
Support received this image and your graph only. Uploads on forum works fine by the way, use Upload button below forum reply field. Threw it at...
That signal is active any time the tool is on, so when you have a signal there, your tool is spinning (probably not a good time to do a...
Relays are Tool Enable (spindle on/off) and Direction (fwd/rev) so not available either. Can technically modify grblhal with your own plugin to...
As we don't have that setup to play with ourselves, best to play around and experiment with what you have on the machine. Some notes : G1 Z0 -...
Not meant that way, laid it out clearly why it says that for you.
Read carefully. Opens it just fine, can run it can use it can preview it all. Just "doesnt show it in gcode editor" The gcode editor with syntax...
CAM is english only. Any translation would be browser trying to be clever.
Check that leadscrews are lubricated (dry/PTFE lubricant not oil) and Grubscrews on shaft couplers are tight. Slots clean etc (nothing that can...
Should also consider supporting (: BlackBox Motion Control System X32 (Full access to tech support for software etc )
I see a WCH Serial device, so knockoff Arduino? (CH431 USB chip, not the more usual AT8u4 from official arduinos) so could be USB drivers (Newer...
Not whether laser is on or not, that matters At some point you possibly changed [ATTACH] To L and 100 or whatever (guessing here based of your...
M3 Sxxxx sets laser power. L is not used in Grbl. S=0 to whatever you have for $32 in Grbl Settings. Usually default of $32=1000 so 50% =...
If you fit an "electro magnetic" switch between the wall and your machine, when power comes back on it will stay off until you reset it...
OpenBuilds CAM doesn't use L50 by default. But you could change its defaults to do that, so likely you did (play around in CAMs advanced...
