Separate names with a comma.
Some features disabled for guests. Register Today.
...G54 (This relies on homing, see Search Results for Query: G53 fusion | OpenBuilds ) G53 G0 Z-0.3937 So that would look like... G90 G21 G17...
...GRBL.) (This relies on homing, see Search Results for Query: G53 fusion | OpenBuilds ) G53 G0 Z0 G0 X42.83 Y2.5 F750 G0 X42.83 Y2.5 Z15 Z2 M3...
...[ (This relies on homing, see Search Results for Query: G53 fusion | OpenBuilds ) ] ok [17:51:05] [ G53 G0 Z-10 ] ok [17:51:05] [ G0 X199.928...
G53 Z-10 is a clearance move. It will move to 10mm below your z limit switch. Then move to the first position. By the looks of the log it...
But rather than the built in fusion Grbl post that uses confusing G28, rather use ours that uses the easier G53 concept as linked above
Use the OpenBuilds Fusion Post: docs:software:fusion360 [OpenBuilds Documentation] Make sure you home your machine before setting work zeros....
Hello! I have a Lead 1010 and I've added a Sharpie pen plotter to it, and I could use some help figuring out the software (specifically how to...
Thank you for the response. I did finally find a post where you addressed this with another member (I think it was called "Z drop" or something...
G0 Z-10 at the start of the job ... Why ? I though this was the end of the code / job When I run the post process (Fusion 360) it always puts...
Checkout =40']Search Results for Query: G53 fusion | OpenBuilds Basically, you either forgot to home (everytime you start), or don't have homing...
I finally got back to my workbee this week and had a chance to test the new Fusion 360 post processor for plasma cutting. It loaded easily into OB...
Then that'll be Fusion's G53 (machine coordinate) move. That moves to where you HOMED the machine. If you don't have limit switches, how is kind...
The simulation looks good. Z starts cutting in the air and then moves into the work piece as intended during simulation. During live however,...
I am using Fusion 360 with the OpenbuildsFusion360PostGrbl post process. I keep getting an Alarm Error at the following location: G90 G94 G17 G20...
i turned off BOTH hard and soft limits and now the job did in fact run but now i have a broken limit switch... guess i have to take the good with...
Hello World job = good Machine profile = good How you assembled the machine, is switches in the correct locations, did you cross any wires? =...
That G53 G0 Z-10 is supposed to be comfortably above the workpiece. If not, that big XY G0 move afterward will do exactly that. It's only getting...
The G53 (machine coordinates, not work coordinates) shouldnt hit your limit switch at all. That's the point of using G53 and not G54 for the...
First of all, the Fusion 360 post is amazingly well thought out... down to the router speed selection! That said, how on earth do I eliminate or...
Program ran fine in Fusion 360 besides the simulation starting at the bottom right, instead of left, which it has done many times in the past...
