Separate names with a comma.
Some features disabled for guests. Register Today.
These are hobby grade systems and they max out around 1m x 1.5m. Anything beyond that gets too flexible to make a decent cut. If you want to go...
If you have a decent stock of 20x40s you can easily knock out some C-beams for this. 20x80s would readily work for the vertical portion of the...
You might take a look at this project: Cut To Length Machine
First determine pitch diameter for the pulleys. Pitch diameter = (number of teeth x tooth spacing) / pi. So in this case pitch diameter = (40 x...
Same story, lay it out using pitch diameter and then let the program calculate the continuous length. Not sure what program you're using but I...
If you're just trying to level out the surface of the 6 pieces hold the sand paper in a U-shape around the wheel. This will give you 180 degrees...
BlackBox Motion Control System
The only real suggestion I can offer is to contact the part store for resolution. Either email Contact Us Form or use the part store contact page...
Lower. I would probably set it in the 8,000 to 10,000 rpm range. If it is still burning at low speed, you need to speed up the feed rate. May be...
Not sure where the problems is. Maybe a different batch on the STS screws or the hinges? Do you have a digital caliper to where you can check the...
Ordering a proper collet for the router makes far more sense than spending extra on router bits. A proper collet is also less dangerous than an...
Sorry but the slots won't work for this. By the time you have tightened the connections up enough to prevent flopping you will have induced too...
In all the years I've been watching the forum I don't recall anyone ever using those slots. That being said, what you seek is not that difficult....
Have you tried basswood?
Is the hole something you could punch rather than drill? A needle on a solenoid would make rather quick work of this.
Pictures, pictures, and... more pictures! :thumbsup:
The biggest issue you will have is the controller and software. This is something you should have fully nailed down before you even begin...
Someone???? :ROFL::ROFL::ROFL: It's where this whole party started.;)
The ACRO is a system designed for use with a laser. You might get away with using a Dremel on the smallest model ACRO but the system lacks a...
Here are a couple of previous threads you may be able to pull some ideas from. Need help with x large build for slab flattening Slab Flattening Table
