Separate names with a comma.
Some features disabled for guests. Register Today.
Hehe, this board have enough drivers? http://www.panucatt.com/Azteeg_X3_Pro_p/ax3pro.htm Fair enough, if you have higher amp draw motor than...
I am using a ramps 1.4 board. You have 5 drivers, X,Y,Z,E0,E1. Most people don't use two separate drivers for the Z axis, they use them in...
Makes sense. Where do you source your filament? Back when I had a working 0.3mm nozzle I used the cheapest filament I could get and would...
What settings are you using in your slic3r?
Not having any issues with the extra mass of the direct feed extruder then? Good to hear.
Try with lower acceleration (5000) and increase if you are happy with it. I typically print at 120-140% of this and have successfully printed up...
In slic3r I start off with the default speeds all around and then increase everything with a % modifier in my LCD controller, not sure if Repetier...
You are forgetting your brackets but we are using the same numbers after you reduce the formula to a single number. #define...
@ruggb If you have all the jumpers in place with the DRV8825s you get 32 micro steps versus 16 you get with the 4988s. 1) Sounds like you've...
I designed it to be drilled out to the right size depending on what size coupling you have. I retrospect I should have just designed two...
It was one from a pack of random springs from PM hobby craft. The benefit of the adjustable idler is you can adjust the tension based on the...
If you can do the pyramid that well (very consistent layers, sharp corners, no artifacts) you should be able to do the vases/T-rex skull that well...
Oh, misread that. That seems weird, can you post a pic? The slots should have enough range to take up the gap that was designed in.
Two possibilities here: 1) The hotend on the right purposely has extra play so that it can be levelled with the other (left) hotend. How does it...
Nice, what nozzle size and layer height are you using there? Those are some pretty fine prints. The nicest I've done was with a 0.3mm J-Head @...
Sorry, I can't help you much here as I didn't use or design this part. NickM came up with it. Here is a photo he shared a while back. Since you...
A couple other options: http://www.makerfarm.com/index.php/heat-beds/8-4-x-12-6-heat-bed.html...
Looks good, you may want to print that out of ABS instead of PLA due to the proximity of the heater blocks to the carriage plate. On that plus...
PCB heater, glass, then simple bulldog clamps. Hair spray for PLA, kapton tape for ABS.
Yes that is right. The pieces could be extended to provide 4 attachment points if desired. You can't attach them on the back side as the belts...
