Separate names with a comma.
Some features disabled for guests. Register Today.
Depending on how many you use on the front bar, 2-4, you will need 10-12 90 corners in total. However, you eliminate the need for a lot of them...
Both of those would be plenty strong, but the later would be stronger since it has the webbing. These would be better...
Nope, only the drives are toothed. Both advantages and disadvantages. The advantage is that idler pulleys wont put pressure on the belt tooth...
Regulars must be inserted from the end of the extrusion where drop in Tees can be put in from the face and then twist to lock into place. A few...
1) Most heated PCB beds come with a M3 hole in each corner. I positioned a printed support under each corner off of the Z frame then attached the...
Interesting, make sure your filament spools spin very easily or there will be variable pressure on one of your Z flexible couplings as the moving...
It could definitely be done. What would be the reason? Increased structural rigidity? The reason 20x40 was chosen was to provide two parallel...
Added, fixed a minor issue with it a month or so back and forgot to re-post it to the files section. I'll take a look at the BOM, they didn't have...
An option: http://protodrake.ca/ Though they apparently don't stock anything!
You can use the 20x80 all along the bottom, but should extend the verticals an extra 4cm so you don't loose print height. You will actually get a...
There isn't a ton of extra space: Front-back is pretty tight. If you use a different endstop design you can save ~1cm. I wouldn't reduce this...
That is crazy. Did not know a heli could be flown is such a manner. Mad skills. Speaking of quads... I have recently delved into the hobby. Of...
That cut off blade should be great. Sometimes a mitre saw doesn't have the range of motion (like a chop saw) to make use of the disk after you...
Not yet as I am in the middle of a printing project and it will take a bit of effort to test out.
One other important note on the DRV8825s, with all the jumpers in place they provide 32 micro steps, not 16. So you will also need to update your...
If you have much trouble with any part then let me know. It is very easy for me to split or modify them.
If you go to the top of page 13 I posted a shroud that works with a 40mm fan (attaches to my dual carriage).
You can fully setup the printer in a single configuration page of Marlin with no code changes, everything being discussed is extras. The E3d v6...
Yep, I am interested. I looked a bit into changing the default home order way back but didn't get very far. I haven't looked at a recent version...
Auto home in Marlin and through the LCD interface always homes in the order X-Y-Z. You could mess is up by homing individual axis' via something...
