Separate names with a comma.
Some features disabled for guests. Register Today.
For a cnc shield using a digital out, you would need a relay. There are many power relay options on the web for Arduino that would work, as long...
Hi Paul, Pictures would help as I'm not sure what you are describing? did you go though the calibration? Post your settings here, and the drawing...
That turned out awesome! I'm surprised while you had the router open you didn't replace the power cable with 16awg shielded (so you can drain and...
Could use a large (maybe 1/2" enough?) ball end bit and use carve, like V-carving. Would have to draw the outside shape of what you want, less...
Good point, this is why with any ER should have a nut for each collet you use, they are not expensive.
wow you must be strong? Did you try a different nut? Can go to home depot and get a Makita to finish your orders.
It's a Lead, with the standard z axis height and single x gantry, run it like you have and upgrade if you find it doesn't accomplish what you...
Looks like they are all red black red black but this one. swapping one pair of wires will change the direction. Gary [ATTACH]
so the A is/was working just going in the wrong direction? swap the two motor wires that are different than the other to get them both going the...
I think you are confusing power wires from the motor with the signal wires coming from your controller board. Move the signal wires from the bob A...
I always thought A was used for rotary axis on mach3? Is the machine setup for dual home switches? I'm sure it's possible to use A for Y2 but...
Ok that helps, so you should see from the controller board Y-Pulse and Y-Direction signal wire running to both Y drives, in parallel, trace those...
There are so many youtube videos on H100.. as you said its hard to find the right one. That's a huge cutter, is it carbide insert type? Is it...
Could be from chatter, or not using a sharp bit, I recommend a down-cut bit on plywood Gary
mach 3 is software, what model drivers/hardware are you using? a pic could be helpful as well. Thanks Gary
I just looked at my inexpensive er11a nuts I found on amazon and they don't look like that one in your pic, and I've had no issues with them. I...
Do you have the collet fully snapped into the nut?
So your lead screw is so tight on the backlash nut it can only be turned by a wrench? lead screw and anti-backlash nut should turn smoothly and...
Most common reason for this -mechanical binding, with the motor disconnected can the screw be turned by hand easily (same on both sides) -bad wire...
Thanks, thought that looked weird, so the relay spec is missing from the docs? [ATTACH] Gary
