Separate names with a comma.
Some features disabled for guests. Register Today.
It's an interesting kit, would have to find real customers (review) experience with the quality of the components. Cheers Gary
Really depends on what you are cutting, everybody will have a preferred method based on the use case. In my case I have the old spoil board full...
Hi Arcuriel, Almost always it's a broken wire or loose connection to the motor. I had the same issue once, broke 4 bits before I realized one...
4-pin to SL cable? Contact the parts store they will help you out. Cheers Gary
The machine lead screw is 10mm with 12thread/inch Are you sure? Might need to carefully measure a full turn of the screw and see how far it...
You can swap any one pair of wires from one coil around to change the direction or reverse the direction in the grbl settings using $3 settings,...
Hi Boinger, move your router cable away from everything, especially the usb cable, and make sure the router and vacuum AC are on a different...
I'm using a 0.8mm 2 flute down-cut to cut 1/16 balsa these days.. I like smaller bits for making tighter corners and less waste. all depends on...
Oh good question, Yes I did run from Estlcam (with the hardware flashed) but for laser I just searched and doesn't look well supported sorry.
[MEDIA] I tried this once it was very easy. Gary
I started out with an Uno and dq542ma drivers (worked perfectly well) but now I'm using a Backbox with Estlcam and using the firmware flash as...
Did you try increasing your current as well? Gary
Lucky that steel has excellent creep resistance.. our plastic wheels on the other hand will get a flat spot. Don't get me started on back emf! Cheers
Are you using a BlackBox? the current is set with the drivers not the software, on the Blackbox there are current adjust pots. When you say...
Hi David, post your file you are using to get the circles, the drawing and the code if you can. The current pots should be ~75% toward full if...
Depends on many factors, like your vacuum, the boot setup, the material. If you are cutting close to the material edge and there is a big leak...
Which post processor are you using?
Hello Dr. Did you remember to home and set your work zero? have to do that every time. It still jogs in the correct directions I assume? Gary
Looks solid! 3d printed blower?
The Granit was one I can think of, very stout. Maybe not exactly what you are describing though. cheers Gary
