Separate names with a comma.
Some features disabled for guests. Register Today.
You need to setup the z probe under controller settings first, then reprogram the mega, after that the tool height or probe will work in estlcam...
Last time I did it was with a 1" bottom clearing router bit, at 1500mm/min 0.5mm doc and I probably had the makita at 3 speed setting, I mostly...
Same..
Hi Poolrod, sounds like you need to calibrate your steps per mm. If using openbuilds standard screws and 1/8 micro stepping, then 200 steps per mm...
My belt driven machine will push clamps out of the way without loosing steps, Use strong motors and good quality drivers that can deliver the...
Thanks for the info, Yes you should always buy enough material for ~20 :) and you can never have enough bolts and slot nuts! Cheers
on and off? sure, using one of these is easiest.. IOT Switch Hookup instruction on the docs Cheers Gary
Your plates look fantastic great work! What is the gold? paint or anodize? Gary
I don't know why but made me think.. if it could cut 7 and a half slices is it really just 8 slices?
Have you trammed the z axis and the spindle? One example of many on how to do it. Cheers [MEDIA]
Enhance..... Enhance..... doesn't work like the movies :(
Kinda Dumb maybe, but estlcam supports tool changes and doesn’t slow down on trochoidal or large (file size) 3D jobs. Gary
Yes can do G-code only for sure. I have also flashed my BB from GRBL to Estlcam (xpro4 preset) and back to GRBL and then back to ESTLcam with no...
One of the four wires has a bad connection. Check every connection, could be a broken wire or bad solder joint, or loose connector. Gary
Hi Alex, as long as the z probing was setup correct and the offset is showing correct on the coordinates you do not need to move the tool down to...
Hi djbart, use a multi-meter and check the voltage of the BB signal, should read 5V DC (at the "toolhead") when the spindle on is commanded. You...
Something like this? Wish Openbuilds carried it!, it's hard to find. Probably cheaper to use 2080 from Openbuilds. Gary
Hi CA, there is Diameter, Pitch and Lead, the dia is 10mm in your case, 2mm pitch this is the per thread or per start pitch, and you can have...
Hi Steve, Yes you can use the BB on an OX (My Ox is using a BB), the configuration is not difficult to do even without a pre-set, we can help you...
Looks good!
